User's Manual

ENG man BRAVO-FUNK-915 00 BRAVO-FUNK-915 Radio remote control system
- Page 18 -
Receiving unit
LED SIGNAL
POSSIBLE CAUSE SUGGESTED REMEDY
Green POWER LED
LED Off
RECEIVING UNIT NOT
POWERED
Check the wiring of the system and that power is
supplied to the plug. If the problem continues, check
fuse F2 (see page 13).
LED on xed NO RADIO LINK
Move the transmitter closer to the receiver.
Check the operation of the transmitting unit (see
paragraph 7.2).
LED ashes slowly OK
OK. The system is working properly.
Red ALARM LED
LED Off OK
OK. The system is working properly.
LED makes 1 ash + 1
pause
STOP OUTPUT ERROR
Check the system's wiring. If the problem continues,
check fuses F3 and F4 (see page 13).
LED makes 2 ashes + 1
pause
SAFETY OUTPUT ERROR
Check the system's wiring. If the problem continues,
check fuses F1 and F5 (see page 13).
LED xed on or ashing in
any other manner
RECEIVER UNIT FAILURE
Contact the ELCA assistance service.
Blue STATUS LED
LED Off
RECEIVER UNIT
INACTIVE
No radio link Check the operation of the transmitting
unit (see paragraph 7.2).
LED ashes slowly
POWER SUPPLY OVER-
VOLTAGE
Check that the supply voltage is within the limits
foreseen for the technical characteristics of the
receiver (see paragraph 3.3).
LED ashes rapidly
DATA TRANSFER IN
PROGRESS
OK. The system is working properly. If the ashing is
discontinuous there are radio link problems: Move the
transmitter closer to the receiver.
LED on
OVER-CURRENT ON A
PWM OUTPUT
Check the wiring of the system and any faults on the
machine.
Yellow SETUP LED
LED Off
NO FAULT IN THE
ADDRESS KEY AND DATA
MEMORY
OK. The system is working properly.
LED makes 1 ash + 1
pause
ADDRESS KEY ERROR
Contact the ELCA assistance service.
LED makes 2 ashes + 1
pause
DATA MEMORY ERROR
Contact the ELCA assistance service.
LED ashes rapidly SYSTEM IN SETUP MODE
The system entered in the "Setup" mode and two
analogue commands were activated simultaneously
(see paragraph 5.3).
LED on xed SYSTEM IN SETUP MODE
The system entered in the “Setup” mode (see
paragraph 5.3).
/
For any other signals not
listed above
Contact the ELCA assistance service.
- MALFUNCTION OF THE RECEIVER UNIT: When the radio link is active and operational and the system works
regularly on the receiving unit, the green POWER LED ashes slowly and the blue STATUS LED ashes rapidly. All other
LEDs are off.
In the event of failure or malfunction, the main signals are summarized in the following table.