User's Manual
ENG man BRAVO-FUNK-915 00 BRAVO-FUNK-915 Radio remote control system
- Page 24 -
PULL, PUSH AND RAPID FUNCTION
The Push function is activated with selector S2 in the upward position. The adjustment of the
thrust force is made using potentiometer POT1.
The Pull function is activated with selector S2 in the downward position and the pulling force is
always the greatest in any position the potentiometer POT1 may be.
The selector S2 and Joystick JOY1 can be simultaneously activated to obtain the maximum
movement speed of the head.
With JOY1 out of zero the push and pull force are always the maximum possible whatever the
position of the potentiometer POT1.
The activation of the Drilling mode (work) with selector S2 active, causes the error signal given
by DL1 "Option Check" that ashes rapidly and all outputs off. To restore the operation, set S2
in the center.
GEAR COMMAND
Keeping the selector S19 pushed forward and activating S3 at the same time enables the
'GEAR' command to change the gear of the head activating the two outputs GEAR1 and
GEAR2 in the following sequence:
1 GEAR-1 - OFF GEAR-2 - OFF
2 GEAR-1 - ON GEAR-2 - OFF
3 GEAR-1 - OFF GEAR-2 - ON
A forward action of S3 (GEAR+) passes to the next step;
A backward action of S3 (GEAR-) returns to the previous step.
In certain congurations, the 'GEAR' command can be activated with selector S18 instead of
selector S19.
With 'GEAR' active, all charger commands are blocked as well as S1, S2, S8.
"SLOW PERCUSSION" ADJUSTMENT
In some congurations there may be a potentiometer in the S19 position instead of the 'GEAR'
selector, to adjust the 'SLOW PERCUSSION'.
MAINTAINED FUNCTIONS
The functions on S4 and S5 (Pump and Percussion) are maintained functions
(Push-Push) meaning that the rst action activates and the second deactivates.
The maintained functions are disabled when the Drilling mode (work) is exited.