User's Manual
ENG man BRAVO-FUNK-915 00 BRAVO-FUNK-915 Radio remote control system
- Page II -
Each BRAVO-FUNK-915 series’ radio remote control working in the frequency band 915-928MHz complies with Part 15
of standards FCC and with RSS-210 of IC standards.
Transmitting Unit AT BRAVO-FUNK-915 FCC ID: 2ABS7-ATBRFU915
Receiving Unit AR BRAVO-FUNK-915 FCC ID: 2ABS7-ARBRFU915
This device complies with part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause undesired operation.
Any changes or modications not expressly approved by the party responsible for compliance could void the user’s
authority to operate the equipment.
The radio link between the units of ELCA BRAVO-FUNK-915 series radio remote controls is built at one of the frequencies
permitted by the US standards in force when the system is put on the market.
Frequency band ............................................................................................. 915-928MHz
Transmitting power ........................................................... meets FCC and IC requirements
Available radio channels .............................................................................................. 259
Channel spacing ...................................................................................................... 50kHz
BRAVO-FUNK-915 series industrial radio remote controls communicate either in dynamic or static mode.
Mode is set by the machine manufacturer
Dynamic mode
A radio remote control communicating in dynamic mode:
- uses a working frequency in the band 915-928MHz
- checks that the frequency is free before using it
- continually changes the working frequency to maintain the radio link even when interference occurs.
Static mode
A radio remote control communicating in static mode:
- uses a working frequency in the band 915-928MHz
- checks that the frequency is free before using it
- always works at the same frequency until the stop function is activated.
- BRAVO-FUNK-915 series’ radio remote controls working in the frequency band 915-928MHz can be used in the
United States market.
a. FEDERAL COMMUNICATIONS COMMISSION (FCC) CONFORMITY AND FREQUENCIES
a.1 CONFORMITY
a.2 FCC CONFORMITY STATEMENT
a.3 FREQUENCIES
a.4 MARKET