User's Manual

ENG man MITO-VETTA 915 00 Radio Remote Control System MITO-VETTA-915
- Page 13 -
ENGLISH
4. BATTERY CHARGER
4.1 OPERATING INSTRUCTION
To obtain maximum performance in terms of charging capacity and useful life of the battery, charging must be carried out
in an environment where the temperature is between 0° C and 40° C.
Check that the poles of the electrical connections are clean and dry before connecting the charging system.
Indicator lights:
When connecting the charging system the Blue light on the transmitter (CHARGE) will light to indicate that charging has
began.
When the battery is fully charged the Blue light on the transmitter (CHARGE) turns off.
The full charging process lasts about 4 hours.
The charging process for the lithium polymer batteries allows to obtain a quick charge in the initial charging phase. The
graph below shows that 75% of the useful loads are obtained in two hours of charging, equivalent to about 37 hours of
run time.
Even a charge of just 20 minutes can ensure approximately 6 hours of run time.
NOTE 1:
Under conditions of high temperature (greater than 45 ° C) or low (below 0 ° C) the Blue CHARGE LED is off, charging
is interrupted to protect the battery due to exceeding temperature limits. The charging process is resumed as soon as
temperature is back within the allowed range.
NOTE 2:
It is advisable to always keep the batteries fully charged to be able to ensure full effectiveness. Avoid leaving the batteries
discharged for long periods. Charge the batteries at least once a year.
Percentuale ricarica
Tempo di ricarica
0,00%
12,00%
50,00%
75,00%
100,00%
0 20 80 120 240
CHARGE PERCENT
TIME OF CHARGE