Operation Manual

Menu: Configuration
Function input H1
(programmable input)
On the LMU programmable input
the following functions can be
selected, that are activated by an
external contact
.
Function input RelCl
On the programmable input of the
clip-in (not the solar Clip-In), the
following functions can be selected,
which can be activated by an
external contact
(function
0,1,2,3,7,8,9,), an analogue signal
(function 4,5) or via a
sensor
(function 6,11).
Line no.
Operating line
Factory setting
5950
Function input H1
Modem function
5978
Function input SolCl
None
5973
Function input RelCl
None
5957
Modem function
Optg mode change HCs+DHW
0 Default, the function « programmable input » is not used
1 Modem function active when contact closed
2 Modem function active when contact open
3 Warm air curtain functio
7 Check sign flue gas damper
8 Burner lock activated when contact closed
9 Burner lock activated when contact open (see description on page 40)
0 Default, the function « programmable input » is not used
1 Modem function active when contact closed
2 Modem function active when contact open
3 Warm air curtain functio
4 Preselected setpoint
5 Preselected output
6 Sensor pressureless header
7 Check sign flue gas damper
8 Burner lock activated when contact closed
9 Burner lock activated when contact open
11 Heat generation lock via temperature sensor (see description on page 40)
0 None
10 Collector sensor (see description on page 40)
Function input SolCl
Modemfunktion
Function selection for modem input.
On which heating circuits, and
whether the modem function is to
act on the drinking water, is set
here.
Selection options:

all heating circuits + DHW

all heating circuits

in heating circuit 1

in heating circuit 2
39