Operation Manual

Menu: Configuration
Config room thermostat 1, 2
Using the parameters, the function of
the input can be programmed as
follows:
Ext. Maximum supply setpoint
Maximum heat requirement for
external temperature preselected
setpoint on the clip-IN AGU 2511,
2513.
Modulating pump speeds
Speed of the modulating pump.
Line no.
Operating line
Factory setting
5970
Config room thermostat 1
Room thermostat
5971
Config room thermostat 2
Room thermostat
0: None
1: Room thermostat
2: Time switch room level
3: Time switch heat request
4: Time switch DHW level
Line no.
Operating line
Factory setting
5975
Ext flow temp setpoint max
80 °C
Line no.
Operating line
Factory setting
6089
Modulating pump speeds
Indication only
Time constant building
When the outside temperature varies,
the room temperature changes at
different rates, depending on the
building's thermal storage capacity.
The above setting is used to adjust the
response of the flow temperature
setpoint when the outside temperature
varies.
Line no.
Operating line
Factory setting
6110
Time constant building
5h
Example:
> 20:
Room temperature responds slowly to outside temperature fluctuations.
10 - 20:
This setting can be used for most buildings.
< 10:
Room temperature responds quickly to outside temperature fluctuations.:
41
41