User manual
28
28 EN
EPIR2 User Manual v.1.4
SMS
User
EPIR2
52
2.3.4. How to disarm & turn o alarm by EKB3W
1. The system will initiate the entry delay countdown (by default – 15 seconds) after the user
has entered the secured area. Entry delay countdown is intended for user to enter a valid user
password and disarm the system before the alarm is caused. `
2. To disarm the system or turn o the alarm, enter any out of 10 available 4-digit user pass-
words using the number keys:
1
7
4
2
8
5
0
3
9
6
Enter user password:
uuuu
Value: uuuu – 4-digit user password
Example: 1111
3. After the system is successfully disarmed, it will reply with conrmation by SMS message to
User 1 phone number (by default).
SMS
User
EPIR2
53
2.3.5. About STAY mode and how to activate it by EKB3W
Stay mode allows the user to remain in the secured area after arming the system. In Stay mode,
the system does not cause the alarm when the zones, set up to operate under this mode, become
violated. This mode is usually used when arming the system before night.
The ways of system arming in Stay mode are the following:
• Automatic - The system becomes Stay-armed if the user does not leave the secured area (if
Delay zone is not violated) during exit delay countdown when arming the system by phone call,
SMS/text message, wireless keypad EKB3W or wireless keyfob EWK1/EWK2
• Manual - The system becomes instantly Stay-armed after the user presses the [STAY] key
and enters a valid user password on the EKB3W keypad. There is no exit delay countdown
when activating Stay mode manually.