User manual

EPIR2 User Manual v.1.4

1. Arm the system in Stay mode manually by entering the following combination using [STAY]

and number keys:

Press the [STAY] key & enter user password:

STAY uuuu

Value: uuuu - 4-digit user password

Example: STAY1111

2. After the system is successfully armed, it will reply with conrmation by SMS message to User

1 phone number (by default).

SMS

User

EPIR2

For more details on how to disarm & turn o the alarm by EKB3W keypad, please refer to section 2.3.4.

2.3.6. Alarm indications & how to view violated zones / tampers by EKB3W

The built-in EKB3W mini-buzzer provide short beeps continuously in case of alarm. In addition, the

violated zone number is indicated by illuminated zone LED or ashing SYSTEM LED (if the violated

zone number is above 12). The violated tamper number is indicated by ashing zone LED or illu-

minated SYSTEM LED (if the violated tamper number is above 12). In both cases. the mini-buzzer

can be silenced by disarming the system using any method.

For more details on EKB3W violated high-number zone & tamper number indication, please refer

to section 2.3.8. Fault messages.

2.3.7. How to bypass a violated zone & activate a bypassed zone by EKB3W

Arming the system is disabled while there’s at least 1 violated zone. Bypassing the zone allows to

temporally disable a particular violated zone and arm the alarm system afterwards.

Bypass a violated zone by entering the following combination using [BYPS], number and [#] keys:

Press the [BYPS] key, enter zone number & user password:

BYPS nn uuuu#

Value: nn – zone number, range – [01... 34]; uuuu – 4-digit user password

Example: BYPS051111#

To activate a bypassed zone, enter the same combination again.

NOTE: The alternative way to activate all bypassed zones at once is to disarm the system.

NOTE: Zones can only be bypassed when the system is not armed.