User manual
33
33
EPIR2 User Manual v.1.4
3. HOW TO PROGRAM THE SYSTEM USING YOUR MOBILE PHONE
NOTE: The system supports a exible management of SMS/text message replies from the
system. This can be congured using ELDES Conguration Tool software.
In order to congure and control the EPIR2 system using SMS/text message, send the text com-
mand to the phone number of EPIR2 from one of the pre-programmed user numbers.
ESSENTIAL INFORMATION FOR PROGRAMING VIA YOUR MOBILE PHONE
• The underscore symbol ‘_’ in these instructions represents a space. So when following in-
structions and typing an SMS/text message, replace the underscore symbol with a single
space.
• Similarly, ‘XXXX’ means password.
• Make sure you don’t leave any spaces at the beginning or end of the message.
• If you receive the message “wrong syntax” please check your message and try again.
Main Settings
Function Command Value Range / Comment Example
Set the SMS
language
LL LL = CZ; EN; EE; FI; FR; DE;
GR; IS; LV; LT; RU; SK; ES
Choose your preferred lan-
guage for the device before
you change the pre-set pass-
word. Use the code shown in
the table on page 42 to set
your device to your preferred
language. Then send the
code via SMS/text message
to the SIM card inserted in
your EPIR2 alarm system.
LT
Change the SMS
password
0000_PSW_XXXX XXXX = [0001... 9999]
All SMS/text message
commands start with a
password, so be sure to
change the default password
to a memorable number. It
must be a four digit number
– anything except four zeros.
Non-numerical characters
such as dots, colons and
spaces are not allowed.
0000_PSW_1111
NOTE: The underscore symbol ‘_’ in these instructions represents a space. So when typing an
SMS/text message, replace the underscore symbol with a single space.