User manual

EPIR2 User Manual v.1.4

6. Set the Output Mode as Siren under Management section in the ELDES Conguration Tool

software.

NOTE: No additional power supply is required for the siren/bell.

NOTE: For a more convenient installation, we recommend using EWS1 and EWS2 wireless sirens.

System condition indication by LED indicator

1. Remove the terminal block from the slot.

2. Loosen the screws of the terminals using a athead screwdriver.

3. Connect LED indicator’s anode lead (longer) to any of 1 kΩ nominal resistor lead and to the

BELL+ terminal, while the cathode lead (shorter) to BELL - / COM terminal.

BELL- / COM

BELL+

resistor 1 kΩ

LED