User manual

48 EN

EPIR2 User Manual v.1.4

4. Screw in the terminals.

5. Insert back the terminal block.

5. Under Management section in ELDES Conguration Tool software, set the Output Mode

as Indicator and under the Output Indication column, enable the check-box (-es)

corresponding to the desired system conditions, e. g. System Armed check-box.

NOTE: The resistor and the LED indicator are NOT supplied with the EPIR2 system and are

NOT mandatory to use. Please, obtain these components from your local store if desired.

5.2. How to connect a sensor to the wired zone

EPIR2 system comes equipped with the wired zone, therefore you may wish to connect a wired

sensor to your system.

5.2.1. Connecting a wired sensor of NO (normally open) type

1. Remove the terminal block from the slot.