User manual
50
50 EN
EPIR2 User Manual v.1.4
6. Insert back the terminal block.
75
7. Set Zone Status of Z2 to Enabled under Zones/On Board section in ELDES Conguration Tool
software.v
5.2.2. Connecting a wired sensor of NC (normally closed) type
1. Remove the terminal block from the slot.
76
2. Loosen the screws of the terminals using a athead screwdriver.
77
3. Connect the Z wire (usually – yellow) of the wired detection device to any terminal of the 5.6
kΩ nominal resistor (supplied with your EPIR2 system), while the other resistor terminal - to
Z2 terminal.