Service manual

— Page 60 —
© January 2013 Aqua-Hot
®
600-D01 Series Hydronic Heating System Service Manual - Rev. A
SECTION 8: DETACHING AND REATTACHING THE DIESEL BURNER
Reattaching the Diesel Burner to the Aqua-Hot
2. The eye-bolt nuts can then be tightened by using a 10mm socket wrench with a 10 inch long exten-
sion. Use extreme caution when tightening down the eye-bolt nuts, over tightening of the eye-bolt nuts
can cause the aluminum blower casing to crack. (Torque Specifications = Approximately 20-40 in. lbs.)
When reattaching the diesel-burner be sure to properly align the diesel-burner before tightening the eye-bolt
nuts. Also, visually inspect all of the rubber grommets on the top and bottom of the diesel-burner’s cast-
aluminum blower casing to ensure they are in place.
DO NOT
over tighten the eye-bolt nuts. Torque specifi-
cations are: approx. 20-40 in. lbs. An improper alignment and/or over tightening of the eye-bolt nuts can
cause damage to the diesel-burner’s cast aluminum blower casing.
CAUTION!
1. The Diesel-Burner is secured to the Aqua-Hot with two eye-bolt nuts that can be swung into place,
after the diesel burner has been properly aligned and set in place.
Step 1: Reattaching the Diesel Burner to the Aqua-Hot
Figure 39
Figure 40
Figure 41