Service manual

— Page 61 —
© January 2013 Aqua-Hot
®
600-D01 Series Hydronic Heating System Service Manual - Rev. A
SECTION 8: DETACHING AND REATTACHING THE DIESEL BURNER
3. Locate the Diesel-Burner’s Controller and connect both plugs.
1. Align the fuel lines on the diesel burner with the fittings on the Aqua-Hot, and
using a 11/16 inch wrench, tighten down both the supply and return fuel fittings.
Be sure to remove the clamps, off of the Fuel Supply and Return lines at the ports on top of the Aqua-Hot prior to
starting the diesel burner, or serious damage will occur to the diesel-burner’s fuel pump.
CAUTION!
Step 2: Reattach the fuel lines to the Aqua-Hot.
Step 3: Plug in the diesel-burner’s controller and mount
Figure 42 Figure 43
Figure 44
If the fuel lines are connected backwards serious damage may occur to the burner’s fuel pump, and the fuel pump will
start to leak Diesel Fuel out of the shaft seal.
WARNING!!!