Service manual

— Page 86 —

600-D01 Series Hydronic Heating System Service Manual - Rev. A

SECTION 9: DIESEL-BURNER COMPONENTS

Ignition Coil:

Replacement Procedure:

1. Disconnect the ignition cables from the ignition

electrodes. Remove the four ignition coil screws

that secure the ignition coil to the protection cap.

Lift the ignition coil and disconnect its wires from

the C-plug harness wires, prior to removing.

2. Disconnect the ignition cables, on the defective

ignition coil, from the ignition electrodes.

3. Connect the new ignition coil cables, to the ignition

electrodes.

4. Connect the new ignition coil’s black (+) and brown

(-) wires to the C-plug harness’ yellow (+) and

brown (-) wires. Attach the ignition coil to the

protection cap with the four ignition coil screws,

then reconnect the ignition cables to the ignition

electrodes.

5. Follow the instructions for reattaching the diesel

burner and test for proper operation.

NOTE:

In order to perform the following procedures it is

necessary to detach and reattach the diesel-burner head. Be

sure to review the section for detaching and reattaching the

diesel burner..

NOTE: If the new ignition coil does not function, check

wire connections and ensure they are properly connected.

Figure 61