Specifications

SIM900 AT Command Manual
SIM900_AT Command Manual_V1.03 190 12/24/2010
=<mode> ERROR
Parameter
<mode> a numeric parameter which indicates whether to display
transfer protocol in IP header to received data or not
0 not display transfer protocol
1 display transfer protocol, the format is "+IPD,
<data size>,<TCP/UDP>:<data>"
Reference Note
z This command will be effective only in single connection mode
(+CIPMUX=0)
z Only when +CIPHEAD is set to 1, the setting of this command will
work
8.2.25 AT+CIPUDPMODE UDP Extended Mode
AT+CIPUDPMODE UDP Extended Mode
Response
+ CIPUDPMODE: (0-2),("(0,255).(0,255).(0,255).(0,255)"),(1,65535)
OK
Test Command
AT+CIPUDPMOD
E=?
Parameters
See Write Command
Response
+CIPUDPMODE: <mode>,[<IP address>,<Port>]
OK
Read Command
AT+CIPUDPMOD
E?
Parameter
See Write Command
Response
OK
ERROR
Write Command
AT+CIPUDPMOD
E=<mode>,[<IP
address>,<Port>]
Parameter
<mode> 0 UDP Normal Mode
1 UDP Extended Mode
2 Set UDP address to be sent
<IP address> a string parameter (string should be included in quotation
marks) which indicates remote IP address
<port> remote port