User's Manual

IC STATEMENT
This device complies with Industry Canada’s licence-exempt RSSs. Operation is subject to the following two conditions:
(1) This device may not cause interference; and
(2) This device must accept any interference, including interference that may cause undesired operation of the device.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de licence. L'exploitation
est autorisée aux deux conditions suivantes : (1) l'appareil ne doit pas produire de brouillage, et (2) l'utilisateur de l'appareil doit
accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d'en compromettre le fonctionnement.
2 Method of application
2.1 Installation schematic diagram(A)
A:Turn off the power supply. Check the dimension of recessed can and the lamp holder type to see whether the retrofit
kit can fit the luminaire.
B: crew clockwise the E26 adaptor into the lamp holder. Tighten.
C: Choose the screws holes (5in or 6in location) according to the size of the recessed can, then fix the V clips holder to the
corresponding screw holes. Refer to the image on the left for 5in recessed can, image on the right for the 6in can.