INSTALLATION GUIDE
Device Dimensions 140.0 128.5 50.0 91.
Mounting Orientation ✓ Side face of chassis rails or draw bar ✓ Top face of chassis rails or draw bar ✓ Bottom face of chassis rails or draw bar ✗ Inclined angles or inclined faces Page 2
Attaching the unit to the Trailer Centre Punch mounting hole location Pre-drill mounting holes with 2-3mm drill Apply lubrication to the screws provided to prevent the stainless steel from binding. With a No.2 Phillips driver bit, Insert 4x self drilling and taping screws into pre-drilled mounting holes with a cordless drill.
Wiring Diagram 4 Right Signal 7 Tail Lights Auxiliary 2 3 Ground 5 Service Brake 6 Brake Light 1 Left Signal Std 7pin Trailer Plug Elecbrakes Device Splice Connectors 1 3 Apply Heat to Solder (Center Section) Strip (10-15mm) 2 Crimp (Both Ends) 4 Apply Heat to Seal (Heat shrink) Wiring Notes • Auxiliary connection is optional, it may be connected to any 12v to 24v constant power source or left unconnected. • Break away systems may be added to the service brake circuit.
Electrical Connections • Elecbrakes must be connected to trailer wiring circuits as outlined in the wiring diagram. • The Service Brake circuit must be disconnected from an existing trailer plug. Ensure it is sealed off and cannot create a short circuit with any other wire or the chassis. • Route the Elecbrakes cable as required, if you internally route the cable through chassis rails, take care to install grommets to prevent cable from chaffing.
Completing Installation • Download and install the Elecbrakes App on your smart phone from the App Store or Google Play. • Connect the trailer to the vehicle and attach the electrical connections. • Turn the vehicles lights on to power up the Elecbrakes unit. • Launch the App, the App will establish a connection with the Elecbrakes unit.
Getting Started • Download and install the ElecBrakes App on your smart phone from the App Store or Google Play. • Connect trailer and turn lights On to power unit. • Launch App, the App will establish connection with device. • Once Connected, the status Indicator will turn red, the name of the Connected Device and Active Program will be displayed • Operating the Brakes will make the Status Indicators turn bright red.
Brake Response Programs • Elecbrakes has 5x user configurable braking programs. • The Active program can be changed by swiping right from the home screen, then tapping the desired row to select the appropriate program. The newly selected program is immediately applied. • Programs can be renamed and fine tuned by navigating to the settings page. • The programs are saved within the Elecbrakes device, any changes made to programs will be accessible to other users when towing this trailer.
Program Settings Setting Name Purpose Program Name Friendly Name Forward Response Brake Response when traveling in forward direction Reverse Response Brake Response when traveling in reverse direction Minimum Response Allows for fine tuning initial brake bite When Tapped Initial Brake Response when status indicator is tapped Page 9
Forward Response • Elecbrakes has 5x user configurable braking programs. • Each of the 5x programs have an independent Forward Response setting. • The Forward Response may be quickly adjusted for the Active program by swiping left from the home screen. Then using the number picker to select an appropriate value. • Updates to the Forward Response are applied immediately once a new value is selected.
Elecbrakes Pty Limited www.elecbrakes.com info@elecbrakes.
