User Manual

Humidity Button
Press the Humidity button to set your desired humidity value(from 30% to 90%,
each press increases level 5% ). Once the room has reached your specified
humidity level, the device will shut off automatically（The LED screen will
display the current humidity continually). The humidifier will automatically spray
mist for 1 minute after being turned on, even if the room has reached the set
humidity level.
When the ambient humidity drops to 5%RH（Relative Humidity）below the set
humidity, the humidifier will reactivate. The cycle will continue until the tank
runs out of water or until the device is turned off.
After one button press, the LED screen will display (default). Mist will
spray no matter the ambient humidity level.
After the second button press, the LED screen will display “30%”. Each subse-
quent press increases the humidity level by 5 %, until the maximum 90% is
reached. (Press and hold the button for 2s to turn off the humidity setting.)
Heating Button
Press this button for a warm mist. Press the button again to increase mist
temperature.
After one button press, the LED screen will display (cool).
After the second button press, the LED screen will display (low heat).
After the third button press, the LED screen will display (medium heat).
After the fourth button press, the LED screen will display (high heat).
It cycles when you continue to press the button.
Note: When using the Heating Button for warm mist, always make sure it is
placed in a secure location out of child's reach to avoid scalding.
- 07 -