User Manual

c. When cleaning the water tank cover and seal ring, do not distort them and
the water tank, air channel, head cover should be installed back in place
after finish cleaning.
d. Due to the higher water hardness in some areas, the surface of atomizing
plate and heating plate are prone to accumulate scale. Users should wash
them regularly with detergent, and clean the inside of the water tank and the
water box every week under the following instruction: Place 5 drops of dish
soap on the surface of the atomizing plate and 5 drops of dish soap on the
heater. Pour in approximately 30mL of water. Use a dish brush or sponge to
clean the atomizing plate, heater, and sink until all lime-scale is removed.
Drain the dirty water and rinse the device twice.
Note: Make sure that the fan remains dry at all times.
2. After entering heating function, the water temperature in the water box is
very high. Therefore, do not clean the machine immediately after shutting
down the machine to avoid scalding. The machine should be shut down for
1 hour before cleaning.
3. Do not soak the water box, water tank with hot water while cleaning.
4. There is an air inlet at the bottom of the machine. When cleaning, do not
immerse the bottom of the machine in water to avoid water entering into the
machine from the air inlet and damaging the machine.
1. Press the locking tab toward the pulling slot to remove the battery
compartment (figure 1).
2. Properly dispose of the old battery.
Figure 1 Figure 2
Replacing the Remote Control Battery
- 11 -