Manual

ELECRAFT BL1 WIDEBAND 4:1 BALUN
R e v B , N o v e mb e r 1 0 , 2 0 0 6
The Elecraft BL1 is a general-purpose wideband balun with a 4:1 impedance ratio. It is intended to match
balanced feedlines to the unbalanced antenna connection of an Elecraft or other manufacturer’s transceiver
or antenna tuner.
Specifications
Power Rating 150 watts maximum.
Bandwidth Input VSWR less than 1.2 when connected to a 200 resistive load, 500 kHz to 55
MHz.
Assembly
 Perform an inventory of all parts in the kit.
Parts List
1 Balun Printed Circuit Board
20 inches of Balun Wire, brown or white sheath
3 Right-Angle Output Terminals
6 #6 Flat Washers
1 Right-Angle PC –mount BNC Connector
3 Thumb Screws
4 Self-Adhesive Mounting Feet
 Install J1, the BNC connector, in the position indicated on the PC board silkscreen
 Cut the sheathed twisted pair cable into two 10-inch (25.4 cm.) lengths.
 Wind 3 turns of the cable through each of the balun core holes. The wire will completely fill the
holes in the balun core. Leave about 1 inch (2.54 cm.) of cable exposed. Wind the turns tightly. The
wire should be flat against the core. You will have to use a small screwdriver to press each turn
against the inside of the core opening to get the third turn through. A few drops of rubbing alchohol
as a lubricant can help get the last turn through. Be patient, it can be done. Use the photo as a guide
 Trim the cable (4 places) to about 1 inch (2.54 cm.).
 Remove the outer sheath from the trimmed ends of the cable and then strip the conductors so only
about ¼ inch (6.3 mm.) of the RED and WHITE colored insulation is exposed.
 Lightly tin the exposed end of each wire.
 Mount the completed transformer in the space indicated on the PCB. Starting with the end of the
board with the BNC connector pass each wire through the hole marked with its color and solder these
four wires to the board.
 At the opposite end of the board, solder the “A”side RED wire to the hole labeled “REDA”and the
WHITE wire to the hole labeled “WHTA 4:1”.
 Solder the “B”side RED wire to the hole labeled “REDB”and the WHITE wire to the hole labeled
“WHTB 4:1”.
 Install the right angle output terminals in the 3 places indicated on the PCB.
 Install a thumb screw and 2 flat washers into each right angle output terminal
 Turn the PCB over and install mounting feet as shown in the photo.