GAS CHOPPER SCOOTER Assembly and User's Manual 88905, 88969

Fig. 1

Rubber Cushion

Backrest

Locking Nuts

Bolts

ASSEMBLY INSTRUCTIONS

BACKREST INSTALLATION

1. Remove the backrest mounting hardware from the GAS CHOPPER SCOOTER™. Attach the

backrest by aligning the backrest frame against the fixed mounting brackets, inserting the bolts

through the rubber mounting cushion, through the backrest frame, and finally through the fixed

mounting bracket on the GAS CHOPPER SCOOTER™. Secure all 4 bolts with self locking nuts.

*Make sure the small rubber cushion is located between the heads of the bolts and the backrest

frame and not between the backrest frame and the fixed mounting brackets. (Fig. 1)

REARVIEW MIRRORS INSTALLATION (SOLD SEPERATELY)

1. Attach mirrors by inserting threaded end of the mirror into each brake lever assembly nut

approximately ½ way. Slide the tightening nut down and secure by turning clockwise. (Fig. 2)

INSERT FUSE

The

GAS CHOPPER SCOOTER

™ is typically shipped from the manufacture without the 10 Amp

fuse inserted in the fuse cylinder. In order for certain features of the

GAS CHOPPER SCOOTER

™

to work properly, the fuse must be inserted before operation.

1. Locate the 10 Amp fuses in the user's bag.

2. Unscrew the fuse cap (counter clockwise) located on the charger receptacle panel. (Fig. 1)

3. Carefully insert the fuse and replace the fuse cap until it is fully tightened. (Clockwise)

Fig. 2

Mirror

Fig. 1