GAS CHOPPER SCOOTER Assembly and User's Manual 88905, 88969

PRE-RIDE ADJUSTMENTS

ADJUST FRONT & REAR BRAKES

The front and rear brakes your GAS CHOPPER SCOOTER™ have been pre-assembled and pre-

adjusted by the manufacture.

However, the cables and brakes may need adjustment if they are not slowing or stopping the GAS

CHOPPER SCOOTER™ properly. The brakes can be adjusted at the handlebar mounted brake levers.

BRAKE ADJUSTMENTS:

1. Determine brake lever has proper slack

*Brake lever cannot be too tight or it can snap the cable!

*Brake lever cannot be to loose or your

GAS CHOPPER SCOOTER™

may not stop correctly

2. To adjust slack, rotate brake adjustment knob to desired position. (Fig. 1)

Check slack by engaging the brake lever.

*Proper slack should be similar to Fig. 2(A properly adjusted brake lever should leave approximately

3/4"- 1" between the brake lever and throttle grip)

3. If desired slack is achieved, rotate the locking nut clockwise until tight. (Fig. 2)

4. If desired brake tension has been achieved, rotate the locking nut clockwise until tight.

5. If brakes do not adjust properly from brake lever location. It must be adjusted at the front and

rear wheel using the cable tension bolt. (Fig. 3)

6. Rotate cable tension bolt in to the left to tighten brake tension and to the right to loosen brake

tension. Once desired position is acheived tighten locknut

7. The

GAS CHOPPER SCOOTER™

should move freely when brake is not engaged

IF THE PROPER TENSION IS STILL NOT ACHIEVED, CHECK THE BRAKE AND CABLE TO ENSURE EVERY

PART IS PROPERLY CONNECTED. DAMAGED OR FAULTY BRAKE COMPONENTS (CABLE, BRAKE

ASSEMBLY) WILL NOT ALLOW FOR THE

GAS CHOPPER SCOOTER™

TO STOP PROPERLY AND

SHOULD BE REPLACED IMMEDIATELY TO AVOID ANY SERIOUS INJURIES TO THE USER OR OTHERS.

REPEAT PROCEDURE UNTIL DESIRED TENSION IS ACHIEVED.

FIG.1

Lock Nut

Adjustment Knob

FIG.2

FIG.3

Brake Cable

Cable Tension Bolt

Locknut