GAS CHOPPER SCOOTER Assembly and User's Manual 88905, 88969

SERVICE & MAINTENANCE

MAINTENANCE

Technological breakthroughs have made components more complex than ever before, and the

pace of innovation is increasing. This on-going revolution makes it impossible for this manual to

provide all the information required to properly repair and/or maintain your GAS CHOPPER

SCOOTER™. In order to help minimize the chances of an accident and possible injury, it is critical

that you have all repair and maintenance work performed regularly.

For more detailed maintenance instructions or for ordering replacement parts please contact

Electra Customer Service / Technical Support Toll-Free at 1-888-467-1234 M-F 10am - 9pm EST

or visiting the company website at www.electraUSA.com. Local bicycle retail stores, which have

service facilities in your area, can also assist you with certain non-electrical repairs or

adjustments that you are not qualified to make or for which you do not have the specific or

specialized tools needed for repair.

HANDLE BARS ADJUSTMENTS

*Refer to Pre-Ride Adjustments in this manual (pg. 9)

LIGHT ADJUSTMENTS

*Refer to Pre-Ride Adjustments in this manual (pg. 9)

BACK REST ADJUSTMENTS

*Refer to Pre-Ride Adjustments in this manual (pg. 10)

REAR VIEW MIRROR ADJUSTMENTS

*Refer to Pre-Ride Adjustments in this manual (pg. 10)

FUSE REPLACEMENT

*Refer to Pre-Ride Adjustments in this manual (pg. 10)

BRAKES ADJUSTMENTS & MAINTENANCE

*Refer to Pre-Ride Adjustments in this manual (pg. 11)

DRIVE CHAIN ADJUSTMENTS & MAINTENANCE

*Refer to Pre-Ride Adjustments in this manual (pg. 12)

FRONT WHEEL REMOVAL/INSTALLATION

1. Loosen the front axle nuts (counter clockwise) (It is not necessary to completely remove the axle nuts)

2. Disengage the retention washers from their seated holes.

3. The front wheel will slide out and be ready for repair. Be sure to support the chopper during

this process to avoid any unnecessary damage to the forks or brake caliper.

4. After repair, reverse the above mentioned process for installation. Be sure that the axle

retention washers are seated properly in their holes before you tighten both front axle nuts.

REAR WHEEL REMOVAL/INSTALLATION

IMPORTANT: Pay special attention to washers, spacers, and their placement on the axle.

1. Loosen the rear axle nuts (counter clockwise).

2. Loosen the chain adjustment eye bolts (counter clockwise) enough so that the wheel can slide forward.

3. Remove the two small bolts from the chain guard and remove the chain guard.

4. Remove brake support bolt on the left side

5. Slide the rear wheel forward so that the drive chain becomes very loose. Once the chain is

loose, you can remove it from the rear sprocket.

6. Remove the right axle nut. Slide the axle to the left while supporting the rear wheel.

7. Once the axle has been removed, you can remove the wheel from the swing arm

8. Reverse this process for installation of the rear wheel.

Continued on Next Page