GAS CHOPPER SCOOTER Assembly and User's Manual 88905, 88969

SERVICE & MAINTENANCE

GAS TANK REMOVAL/GAS DISPOSAL

TOOLS NEEDED:

1 Phillips Screwdriver

1 10mm wrench

1 Draining container or pan

REMOVE SEAT & GAS TANK COVER:

1. Locate seat screws under the back side of the seat(Fig. 1)

2. Remove screws from seat and pull up(Fig. 1)

3. Remove gas cap and screws from gas tank cover (Fig. 2) and lift up slightly to expose the ignition

wires(Fig. 3)

4. Unplug Ignition wire and pull off gas tank cover

REMOVING GAS TANK

1. Remove fuel lines from gas tank (Fig. 3)

2. Keep gas tank supported to avoid spillage and remove screws (Fig. 4)

REMOVING EXCESS FUEL FROM CARBURETOR

1. Place fuel lines in draining container or pan

2. Push primer ball until all excess fuel empties into draining container or pan (Fig.5).

REINSTALLING FUEL LINES

Make sure fuel lines are properly snapped into tank.

2. Make sure the fuel line (Black) reaches the

bottom of tank (Fig. 6)

3. Make sure both fuels are connected to

carburetor and are not touching the motor.

FUEL LINES CANNOT RUB OR TOUCH AGAINST

THE MOTOR. FUEL LINES MAY MELT FROM HEAT

OF MOTOR.

OVERFLOW LINE

(CLEAR TUBE)

GAS LINE

(BLACK TUBE)

GAS LINE MUST

REACH BOTTOM

OF TANK.

B .

IF GAS LINE DOES NOT REACH

BOTTOM OF TANK, MOTOR-BIKE

WILL NOT FUNCTION OR RUN

PROPERLY.

Fig. 6

Fig. 5

Primer Ball

Fig. 1

Fig. 2 Fig. 3

Ignition Wires

Fuel Lines

Fig. 4