I N F O I S T R U Z I O N I P E R L’ I N S T A L L A Z I O N E E L’USO INSTALLATION AND INSTRUCTION MANUAL INSTALLATIONS- UND GEBRAUCHSANWEISUNG FRIGORIFERO-CONGELATORE «NO FROST» ER 3025 I FRIDGE-FREEZER «NO FROST» ER 3025 I KÜHL-GEFRIERSCHRANK «NO FROST» ER 3025 I 2222 002-63 This document was created with FrameMaker 4.0.
CONTENTS Warnings . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . page 10 Installation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . page 11 Positioning . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . page 11 Electrical connection . . . . . . . . . . . . . . . . . . . . . . . . . . . . . page 11 Cleaning the interior . . . . .
WARNINGS It is most important that this instruction book should be retained with the appliance for future reference. Should the appliance be sold or transferred to another owner, or should you move house and leave the appliance, always ensure that the book is supplied with the appliance in order that the new owner can be acquainted with the functioning of the appliance and the relevant warnings. These warnings are provided in the interest of safety.
INSTALLATION If this refrigerator featuring magnetic door seals is to replace an older appliance having a spring lock (latch) on the door or lid, be sure to make that spring lock unusable before you discard the old appliance. This will prevent it from becoming a death-trap for a child. Positioning The appliance should be installed well away from sources of heat such as radiators, boilers, direct sunlight etc.
Instructions for total built-in Door reversibility (Fig. 1) P P A P1 P1 D114 Fig. 1 Right opening Housing’s dimensions Remove the pins (P) and (P1). Left opening Remove (P) from both sides and the door. Remove (A) from the left side. Refit door and «P» on the left side. Remove «P1» from the right side. Height Depth Width 1780 mm 550 mm 560 mm Push in the appliance into the housing until joint cover (A) butts against kitchen furniture. For appropriate venting, follow indications in Fig. 2 Fig.
Fig. 4 If after having carried out the operation described prev i o u s l y t h e re i s still some space left between the appliance and the kitchen unit, fit the trimming provided together with the appliance on the stop strip (A). A D265 Fig. 8 Position the runners (H) inside the kitchen unit door as shown in Fig. 8 and mark the position of the external holes. After preparing the holes, screw the runners to the kitchen unit door using 3.5x16 mm screws. H 20m m D094 Fig. 5 Fig.
OPERATION The freezer compartment of this model is of the «frost-free» type. This means that no frosting occurs on the inner walls of the compartment or on food during operation. The absence of frosting is achieved by constant circulation of cold air inside the compartment, produced by an automatic fan blower. Movable shelves The walls of the refrigerator are equipped with a series of runners so that the shelves can be positioned as desired. Fig.
Freeze only high-quality, fresh and thoroughly cleaned food; prepare the food to be frozen in small portions. This not only ensures rapid freezing, but it also enables you to use a part of the product instead of having to wastefully thaw the entire piece. If there is a power failure, do not open the door during the whole time of the failure. If the compartment is fully loaded, frozen food is not affected if the power failure is short. Otherwise it is recommended to use the food within 24 hours.
MAINTENANCE Unplug the appliance before carrying out any maintenance operation. Periodic cleaning Clean out the interior periodically with lukewarm water and some bicarbonate of soda. Replacing the interior light bulb The light inside the refrigerator compartment is easy to get at through the opening in the light holder. If the light does not go on when the door is open, check that it is screwed into place properly. If it still does not light up, change the bulb.