Operation Manual

BNET (a BSX ™ Product) Operation Manual
Office: 972 (0) 73-3354727 Fax : [phone] Page 13 of 17
4. CHAPTER 4 – Deployment and Operation
4.1. SCOPE
This chapter provides the procedures for maintenance and operational system
deployment. In addition, this chapter provides the procedures for system deployment,
including specification of required personnel, tools, and materials.
4.2. DEPLOYMENT
This section provides the procedures for maintenance system deployment of BNET
vehicular.
4.2.1. BNET VEHICULAR
This section describes the BNET vehicular deployment.
4.2.1.1. BNET Operational Deployment
When installing in vehicle- (see figure 4-1)
a. Place the BNET (1) on the BNET adapter (6).
b. Hand tighten two hooking devices
(2) that attach the BNET (1) to the BNETadapter (6).
*for office installations-
c. Connect power cable to PWR J9 connector (4).
d. Connect GPS antenna cable to J8 connector (3).
e. Connect UHF antenna cable to J2 connector (5).
f. Power up the vehicular BNET according to section 4.2.2.