User Manual

Page 5 of 9
PARTS LIST
INSTALLATION
This unit can easily be moved from one room to another. While moving the unit please note that it must always be
kept upright and then placed on an even surface.
 Remove any packaging - keep the air cooler in a vertical position.
 Make sure all parts are present and unit is assembled correctly - including the castor wheels (these need to
be pushed into place on the base of the unit)
 Water tank: when filling the tank ensure not to fill above the MAX level.
 When humidifying, the water level must not be lower than the MIN water line.
 If you want to increase the cooling effect, you can put ice or the charged ice packs into the water tank, but
be sure that by adding ice or icepacks the water level does not go over the MAX limit. Empty some water
before adding the ice packs if necessary.
 Make sure filter pad is properly inserted at the back of the unit
 Connect the power plug to a working socket, and then press the power button.
Note: If you want to clean the tank wait until unit has been powered-off for 2 minutes.
ICE PACK
The ice pack slowly absorbs heat from the water in the tank to reduce the temperature of the water. This will
help reduce the temperature of the air blowing out of the cooler. Place the ice pack in the freezer until it is
completely frozen before placing it into the water tank. Ice cubes could also be used as an alternative source of
cooling.
NOTE: 1. The Ice Pack is reusable, do not attempt to open or drain.
2. Do not consume the contents of the Ice Pack.
*Design of ice pack may vary