User Manual

Page 7 of 9
MAINTENANCE
CLEANING
ATTENTION: Please shut off the unit and unplug from the mains before cleaning or performing any
maintenance.
CLEANING THE SURFACE
Clean the plastic housing with a duster or a soft wet cloth.
Do not use chemical solvents (such as benzene, alcohol or gasoline) as they may cause irreversible damage.
Make sure no water enters the control panel.
CLEANING THE WATER TANK
Unplug the power cord, remove the honeycomb filter bracket and then remove the water tank cover. With a
cloth (dipped in a mild detergent), wipe the water tank then rinse it with water.
Draining the water reservoir and refilling with fresh water at least once a week will help reduce any mineral
deposits and keep the filters clean.
Do not run the unit in cooling mode with stale water in the tank.
We recommend emptying the tank and refilling it with fresh water if water has been standing in the tank for an
extended period of time.
MAINTAINING AND CHANGING THE HONEYCOMB FILTER PADS
The appliance is supplied with Honeycomb cooling / filters pads. The cleaning frequency for the Honeycomb filter
depends on local air and water conditions. In areas where the mineral content of the water is high (hard water),
mineral deposits may build up on the honeycomb cooling filter and restrict air flow. If mineral deposits remain on the
Honeycomb pads, the filter should be removed and washed under fresh water. We recommend cleaning the
honeycomb filter at least every two months, depending on your needs.
For best results, allow the honeycomb filter to dry after each use by turning off the cooling function for 15
minutes (with empty water tank) before turning the unit off.
Unplug the power cord, then remove the honeycomb filter frame. Take the honeycomb filter out of the bracket.
With a mild detergent and a soft brush, scrub the honeycomb filter, clean with water and dry
END OF SEASON MAINTENANCE：
1. Empty the tank and wash it with warm soapy water.
2. Dry the tank before placing it back in the unit
3. Clean the Honeycomb pads
4. Store the Icepack in the water tank
5. Cover the unit and keep it in a dry place.