AIRCUBE® PORTABLE AIR CONDITIONER DEHUMIDIFIER, HUMIDIFIER AIR PURIFIER* USER MANUAL Thank you for choosing ElectrIQ Please read this user manual before using this innovative appliance and keep it safe for future reference. Visit our page www.electrIQ.co.
CONTENTS 1．SAFETY INSTRUCTIONS 3 2．FEATURES AND PARTS LIST 4 3．INSTALLATION 5 4．OPERATION AND SETTINGS 7 5．WATER-DRAINAGE 12 6．MAINTENANCE 13 7．TROUBLESHOOTING 14 8．APPENDIX 15 Page 2 of 16
SAFETY INSTRUCTIONS Important! Carefully read the instructions before operating the unit. Note: This appliance is for indoor use only. Rating: This unit must be only connected to a 220-240 V / 50 Hz earthed outlet. Installation must be in accordance with regulations of the country where the unit is used. If you are in any doubt about the suitability of your electrical supply have it checked and, if necessary, modified by a qualified electrician. This appliance has been tested and is safe to use.
FEATURES AND PARTS LIST 1.
INSTALLATION Warning：Before using this unit, please keep it upright for at least 3-4 hours. This unit can easily be moved from one room to another. While moving the unit please note that it must always be kept upright and then placed on an even surface. Unpacking Open the box and remove all the packing out of way. Grip the unit by the carry handles located on either sides of the unit and carefully lift until it slides out of the foam base.
Installation of window kit If you want to use the unit more than a spot cooler we recommend to vent it out using the supplied window kit. Partially open the window and then fix the window kit to the window either horizontally (fig.1) or vertically. Clip the other end of the hose with the fishtail adapter to the air outlet of the window slider. Make sure the unit is upright and there are no obstructions to the air inlets and outlet grills.
OPERATION AND SETTINGS This portable air conditioner boasts four functions: cooling (spot cooling or vented), dehumidifying, humidifying, air cleaning (with optional HEPA filters) / fan and humidifying. The fan has three speeds: high, medium and low Temperature range settings are: 17-300C The unit will also display operating function, temperature, humidity, fault diagnostic and protective functions on the LCD screen.
OPERATION GUIDE When plugged in the unit is automatically in standby status POWER KEY Press Press this button to turn the unit on and enter cooling mode. Press again and the unit will switch off. FUNCTION Press this key to choose Air Conditioner, Dehumidifier, Humidifier or Air Purifier Mode (with optional HEPA filters). TEMP- and TEMP+ button: sets temperature in air conditioning mode. Temperature can range from 17- 30℃.
swinging louvres and hot air coming through the back. Please note that in this mode the temperature in the room will not be reduced. You may use the air conditioner in an open vented fireplace as heat will raise from the back of the unit while cooling through the front. We recommend venting the air conditioner with the vent kit supplier through the wall or through the window and using it in a room of appropriate size.
HUMIDIFIER MODE Select the humidifier mode from function button. The AirCube is a powerful 5 litres per day humidifier. If your room is too dry or suffering from allergies, your AirCube will help maintaining the exact humidity level you need. The AirCube intelligent micro-computer will measure the exact humidity in the room and only add enough moisture to achieve the set humidity. Initially add approximately a liter of water via water filling port (13) behind the filter.
ALARM When the water tank is full, E4 will be displayed on the LED panel. To resume operation, please empty the tank if in Dehumidifier mode, or remove the rubber cap from drain hose, wait for internal tank to empty than empty the main tank if in Air Conditioner mode. The E4 warning will disappear after draining, and the unit can be restarted by pressing the Power On key. E8 error / air filter change indicator can be reset by pressing the FAN SPEED key on the control panel for 3 seconds.
Multi protective function 1.1 Anti-freezing protecting control: When the ambient temperature is low while in Air Conditioner or Dehumidifier mode, the compressor and water pump will stop working if the copper coil temperature is too low. When the copper coil temperature increases, the operation will resume. 1.2、Water-full protection: When the water level in the internal / or external water tank is surpassing the maximum level, the unit will alert automatically and E4 will be displayed on the LED screen.
Continuous drainage: 1.1 Remove the rubber water stopper (do not remove the water tank). 1.2 Use a water pipe to connect to the water outlet. 1.3 You can plumb this pipe into your current plumbing system, lead it outside or use it in a conjunction with a water pump (e.g. cellar use). 1.4 This mode is recommended for dehumidifier mode continuous unattended operation. Notes: When the unit is in the air conditioner mode, it is recommended not to have the water drain pipe installed.
End of Season Maintenance： 1. Disconnect from main power. 2. Pull out the plug from the drainage hole and empty the internal tank. You can also drain the water by leaning the unit toward the water tank. 3. Empty the external tank 4. Then plug back and switch the unit to low fan mode in air cleaning mode. 5. Keep the unit in this mode for half day - until the conduit is dried. Doing this helps to keep the inside of the unit dry and prevents mold developing 6.
APPENDIX Disposal: Do not dispose this product as unsorted municipal waste. Collection of such waste must be handled separately as special treatment is necessary. Recycling facilities are now available for all customers at which you can deposit your old electrical products. Customers will be able to take any old electrical equipment to participating civic amenity sites run by their local councils.
ElectrIQ UK SUPPORT www.ElectrIQ.co.uk/support Please, for your own convenience, read the troubleshooting guide before calling the service line. If the unit still fails to operate call: 0871 620 1057 or complete the online form Also check: 1. Has the unit been standing upright for at least 2 hours? 2. Is the unit plugged into the mains? 3. Is the fuse OK? 4. Switch the unit off and wait three minutes to see if the issue is resolved. Restart the unit. 5. Check if the water tank is full.
