User manual

Page 5 of 16
INSTALLATION
Warning：Before using this unit, please keep it upright for at least 3-4 hours.
This unit can easily be moved from one room to another.
While moving the unit please note that it must always be kept upright and then placed on an even
surface.
Unpacking
Open the box and remove all the packing out of way.
Grip the unit by the carry handles located on either sides of the unit and
carefully lift until it slides out of the foam base.
Open the water tank (15) and remove the exhaust hose (7) as in picture.
Remove the side mount clip (10) from hot air inlet (9)
Install the exhaust hose (7) if operating the unit in vented air conditioning
mode or spot drying mode
PACKAGE CONTENTS
1 / Air Treatment unit 2 / Remote control
3 / Side mount clip (10) 4 / Hose and window kit
5 / HEPA filters (available to be purchased separately)
Assemble the hose (for vented air conditioning mode and directional drying)
1. Remove the hot air exhaust hose (7) from the water tank (15). The fishtail (6) parts (a) and (b)
are stored within the hose (7). Prepare both parts (a) and (b) of hose adaptor and clip them
together. Do not push too hard as this may cause damage. Fr
2. Open filter (8) and remove hot air exhaust mount adapter (10) from its storage. Clip the hot air
exhaust mount (10) over hot air outlet (11) making sure it clicks into place.
The procedure is illustrated bellow.
1. Insert the hose (7) in to the fishtail (6) and rotate it at least 3 times until in place
2. Make sure hot air exhaust mount adapter (10) is clipped to the unit
3. Insert the assembled hose and fishtail
4. Rotate is firmly into adapter. To screw it into place should take no less than three rotations.
The procedure is illustrated bellow.
Note: To remove the hose and adapter reverse the procedure