User manual

Page 8 of 16
OPERATION GUIDE
When plugged in the unit is automatically in standby status
POWER KEY Press Press this button to turn the unit on and enter cooling mode.
Press again and the unit will switch off.
FUNCTION Press this key to choose Air Conditioner, Dehumidifier, Humidifier or
Air Purifier Mode (with optional HEPA filters).
TEMP- and TEMP+ button: sets temperature in air conditioning mode.
Temperature can range from 17- 30℃. Those keys increment or decrement the
preset temperature by 1
℃
each time they are pressed within the 17- 30℃ range.
HUM- and HUM+ during dehumidifying & humidifying function：This key
increment or decrement the preset the preset humidity by 5% each time it is pressed
within 30- 90% range.
LCD DISPLAY
The display indicates the current setting temperature, humidity or the timer settings and
will be accompanied by temperature (
℃), humidity (%) or hours (H) signs.
When the set temperature or the timer is adjusted, the new setting is shown then the
display returns the current set temperature.
The display will also show function modes and fan speed informations.
※ The display is also used to show error codes should a fault occur, see ERROR CODES.
FAN SPEED HIGH→MEDIUM→LOW and AUTO
If "AUTO" is selected during cooling function the fan speed will automatically be
adjusted to HIGH, MEDIUM or LOW according to the difference between settings and
ambient temperature.
TIMER
Press the icon to select your desired operation time periods.
Use the TIMER button to turn on / off the unit after the set time is over.
You can only set the auto-shut off timer while the unit is operating (on)
You can only set the auto-start timer while the unit is in standby (off)
You can set the function and fan speed while setting the timer.
Pressing the POWER key before count down turns the unit on or off will clear the
settings
AIR CONDITIONER MODE
Select the air conditioner mode from function button.
Use TEMP- and TEMP+ keys to set temperature in air conditioning mode. Those
keys increment or decrement the preset temperature by 1
℃
each time they are pressed
within the 17- 30℃ range. The AirCube is a fully climate control Air Conditioner. If
temperature in the room is higher than set temperature the micro-computer will start
the compressor, cooling down.
Also AUTO function can be set for easy operation.
You can use the air cube as personal / spot air cooler with cold air blowing through the