Owner`s manual

Stop Treatment

If the patient presses the hand-held patient cut-off

switch (also see “Emergency Stopping, page 12),

the treatment will end immediately and the status

screen will display "Patient Cancelled Treatment".

The system will vent and needs to be reset (see below).

lf during a treatment the stop button is pressed

(page 12), the treatment will end immediately and the

status screen will display "Treatment Cancelled by

Stopping". The system will vent and needs to be

reset.

Following a successful treatment the timer resets and

the status screen will read "Treatment Time Finished".

The system will vent and needs to be reset.

Reset Button

The reset button appears below the status

display (see right). The reset button resets

the air-system for another treatment and

saves the current settings. It is necessary

to press the reset button at the end of each

treatment.

8.3 Cervical Auto-Distraction

Using Cervical Distraction

Insert the Cradle - First insert the cradle

assembly into the receptacle at the

end of the headpiece (A, photo 24).

Position the Patient - Gently insert the

patient’s neck into the cradle support

with the insert pad facing the ceiling.

Tighten the tension knob until the pa-

tient feels a slight inward pressure (A,

photo 25). Secure the forehead straps

with the Velcro connectors and tilt the

headpiece about 5-10° (photo 24).

Grasp the patient’s ankles and gently

pull towards the foot end of the table to

ensure that the patient’s occipital re-

gion rests upon the upper inside ridge

of the cradle support (photo 25).

photo 24

photo 25