Owner`s manual

Basic Table Operation

3.1 Preparing the Air-Flex for your patient

Plug your table into any 110 volt

grounded outlet (or 220 volt - international).

Paper Roll - Feed the paper through the

face cutout, around the paper bar (just

below the cutout) and over the headpiece

as shown. Close the paper cutter located on

the side of the headpiece (photo 1) and tear

off the excess.

Preparing the Air System

Press the green POWER button on the

Control Panel to use the table’s air-sys-

tem. Each of the function buttons will light

consecutively and then turn off. The table’s

air-compressor may also turn on to replen-

ish the air-supply. The compressor will stop

when the pressure reaches 90 lbs.* See 5.1,

“Using Air-Drops” for air-feature instructions.

*If the air-compressor runs for more than 2-3

minutes, call for service (see page 17).

Note: The Air-Flex is equipped with an

Auto Shutdown mode which will power

down the main control board if the table

is inactive for 2 hours. Press the green

power button to power the board back up.

Note: It is very important that all three

locking handles are firmly locked, point-

ing towards the floor before positioning

your patient on the table (photo 3). This

will prevent unwanted movement and

potential injury to the patient. If your

table has a Thoracic Breakaway, be sure it is also locked before positioning

your patient (photo 4).

3.2 Height Pedal

The basic Air-Flex is equipped with a corded foot pedal (#9 under “Product

Features”) which controls the table height. Press the right side of the pedal

to elevate; the left side to lower. For tables equipped with a rocker foot pedal

(#10, page 2), height may be adjusted from either side of the table.

photo 2

photo 3

photo 1

photo 4

Unlock

Lock