AIRFLEX 15 PORTABLE AIR CONDITIONER WITH HEAT PUMP USER MANUAL Thank you for choosing ElectrIQ. Please read this user manual before using this innovative Air Conditioner and keep it safe for future reference. Visit our page www.electrIQ.co.
CONTENTS 1． ．SAFETY INSTRUCTIONS ………………………………….. 3 2． ．FEATURES AND PARTS LIST ………………………….... 4 3． ．INSTALLATION …………………………………. …………. 5 4． ．CONTROL PANEL AND SETTINGS …………………….. 7 5． ．OPERATION MODE ,,,,,,,,,,,,,,,,,,,,,,,,……………………….. 9 5． ．WATER-DRAINAGE …………………………………………. 14 6． ．MAINTENANCE ……………………………………………… 14 7． ．TROUBLE SHOOTING …………………………………. …. 15 8． ．APPENDIX …………………………………………………….
SAFETY INSTRUCTIONS Important! • Carefully read the instructions before operating the unit. • This Air Conditioner has an IP24 rating. It is designed mainly indoor use only but will stand outdoor use being protected against light rain and splashing. • Rating: This unit must be only connected to a 220-240 V / 50 Hz earthed outlet. • Installation must be in accordance with regulations of the country where the unit is used.
FEATURES AND PARTS LIST 1.
INSTALLATION Warning： ：Before using this unit, please keep it upright for at least 3-4 hours. This unit can easily be moved from one room to another. While moving the unit please note that it must always be kept upright and then placed on an even surface.
Assemble hose fish tail adaptor: Prepare both parts of hose adaptor and clip them together. Do not push too hard as this may cause damage. Extend one head of the hose and screw the adaptor to it. Note: to screw it into place should take no less than three rotations Installation of window kit Partially open the window and then fix the window kit to the window horizontally or vertically. Keep at least 50 cm from any objects and the air inlets grills on the side of the unit.
CONTROL PANEL AND SETTINGS This portable air conditioner boasts four functions: cooling, heating, dehumidifying. The fan has three speeds: high, medium and low Temperature range settings are: 18--300C The unit will also display operating function, temperature, fault diagnostic and protective functions on the LED screen. Control instruction： ： Control panel： ： When plugged in the unit is automatically in standby status (1) POWER button Press this button to turn the unit on and enter cooling mode.
resume operation, please remove the rubber cap of the drain hose and empty the tank. The E4 warning will disappear after draining, and the unit can be restarted by pressing the POWER key. (6) SPEED Fan button HIGH→MEDIUM→LOW and AUTO If "AUTO" is selected during cooling function the fan speed will automatically be adjusted to HIGH, MEDIUM or LOW according to the difference between settings and ambient temperature. e.g. if ambient temperature is 9°C higher than set temperature, the fan will run on High.
3. Multi protective function 3.1 Anti-freezing protecting control: When the ambient temperature is low while in Cooling Mode, the compressor and water pump will stop working if the copper coil temperature is too low. When the copper coil temperature increases, the protection will be stopped automatically. 3.2、Water-full protection: When the water level in the internal water tank is surpassing the maximum level, the unit will alert automatically and E4 will be displayed on the LED screen.
COOLING On very warm days we recommend programming the unit to start early, before direct sun hits the room to cool and set it to a comfortable 20-22°C. ElectrIQ Airflex 15 is a self-evaporating air conditioner, so under normal use there will be no need to empty the internal tank. However if there is a high amount of humidity in the air or the unit is not vented correctly water will be collected in the internal tank.
Place the unit in the shade if possible and in a cool, protected place in order to increase efficiency and to avoid overheating. At an ambient temperature of over 32°C, the unit will stop cooling protecting the compressor. If this become recurrent we recommend you use the INDOOR COOLING OPERATION. We recommend that drainage hose for condensation water must be connected. Set the function to „COOLING“. The selectable temperature range is between 17°C and 30°C.
HEATING WHEN AC IS PLACED OUTDOOR Connect the Hot air hose as displayed in the illustration after exchanging the grills. The air hose will expel the cold air from the room outside while the front grills produce hot air. The unit is placed outside the room to be heated. Outdoor operation is ideal for the autumn period in which outside temperatures do no fall below 10°C. (If the outside temperature should however fall below 10°C continuously, we recommend indoor operation).
WATER-DRAINAGE This model is an advanced self-evaporative air conditioner, which reduces the need to empty the water tank in cooling mode. If the unit is vented correctly most of the water is reused to cool the condenser coils and any excess is evaporated. Please do not use continuous drainage if you intend to use the self-evaporating facility for improved cooling effect. Do not use air exhaust hose vented out if you want to maximise the dehumidifier mode water extraction. 1. Manual drainage: 1.
Maintenance Cleaning Please shut off the unit and unplug from the mains before cleaning or performing any maintenance Clean the surface Clean the plastic housing with a duster or a soft wet cloth. Do not use chemical solvents (such as benzene, alcohol or gasoline) as they may cause irreversible damage. Air filter cleaning a) Clean the air filters every 2 weeks. If the air filter is blocked with dust, the unit’s performance will be significantly affected.
End of Season Maintenance： ： 1. Pull out the plug from the drainage hole and empty the internal tank. You can also drain the water by leaning the unit. 2. Then switch the unit to low fan mode in cooling mode at set > than ambient temperature (this way unit will work in fan mode only) 3. Keep the unit in this mode for half day - until the conduit is dried. Doing this helps to keep the inside of the unit dry and prevents mold developing 4. Turn off the unit and pull out the plug. 5.
APPENDIX Disposal: Do not dispose this product as unsorted municipal waste. Collection of such waste must be handled separately as special treatment is necessary. Recycling facilities are now available for all customers at which you can deposit your old electrical products. Customers will be able to take any old electrical equipment to participating civic amenity sites run by their local councils.
ElectrIQ UK SUPPORT www.ElectrIQ.co.uk/support Please, for your own convenience, make these simple checks before calling the service line. If the unit still fails to operate call: 0871 620 1057 or complete the online form 1. Has the unit been standing upright for at least 2 hours? 2. Is the unit plugged into the mains? 3. Is the fuse OK? 4. Switch the unit off and wait three minutes to see if the issue is resolved. Restart the unit. 5. Check if the water tank is full.
