User manual

Page 3 of 17
SAFETY INSTRUCTIONS
Important!
• Carefully read the instructions before operating the unit.
• This Air Conditioner has an IP24 rating. It is designed mainly indoor use only but will stand outdoor
use being protected against light rain and splashing.
• Rating: This unit must be only connected to a 220-240 V / 50 Hz earthed outlet.
• Installation must be in accordance with regulations of the country where the unit is used.
• If you are in any doubt about the suitability of your electrical supply have it checked and, if
necessary, modified by a qualified electrician.
• This air conditioner has been tested and is safe to use. However, as with any electrical appliances -
use it with care.
• Disconnect the power plug from socket before dismantling, assembling or cleaning.
• Avoid touching any moving parts of the appliance.
• Never insert fingers, pencils or any other objects though the guard
• This appliance is not intended for use by persons (including children) with reduced physical,
sensory or mental capabilities. It is also not intended for use by those with a lack of experience
and knowledge, unless they have been given supervision or instruction concerning the use of the
appliance by a person responsible for their safety.
Do not leave children unsupervised with this appliance.
• Do not clean the unit by spraying it or immersing it in water.
• Never connect the unit to an electrical outlet using an extension cord. If an outlet is not available,
one should be installed by a qualified electrician.
• Never operate this appliance if the cord or plug is damaged. Ensure the power cord is not stretched
or exposed to sharp object/edges.
• A damaged supply cord should be replaced by the manufacturer or a qualified electrician in order
to avoid a hazard.
• Any service other than regular cleaning or filter replacement should be performed by an authorized
service representative. Failure to comply could result in a voided warranty.
• Do not use the appliance for any other purposes than its intended use.
• The air conditioner unit must always be stored and transported upright, otherwise
irreparable damage may be caused to the compressor; if in doubt we suggest waiting at
least 24 hours before starting the unit.
• Avoid restarting the air conditioning unit unless 3 minutes have passed since being turned off. This
prevents damage to the compressor.
• Never use the mains plug as a switch to start and turn off the air conditioning unit. Use the provided
ON/OFF switch located on the control panel.
• Always place the unit on a dry and stable surface.
• The appliance should not be installed in laundry or wet rooms
Energy Saving and Unit Safety Protection Tips
• Do not cover or restrict the airflow from the outlet or inlet grills.
• For maximum performance the minimum distance from a wall or objects should be 50cm. Unit is
fitted with thermal cut off sensor that will prevent overheating
• Keep the filters clean. Under normal conditions, filters should only need cleaning once every three
weeks (approximately). Since the filters remove airborne particles, more frequent cleaning
maybe necessary, depending on the air quality.
• For the initial startup set the fan speed to maximum and the thermostat to 4-5 degrees lower than
the current temperature. After, set the fan switch to low and set the thermostat to your desired
setting.
• To protect the unit we recommend not using the cooling function when the ambient temperature is
higher than 35°C.
• To protect the unit we recommend not using the heating function when the ambient temperature is
lower than 7°C. Use electrical or alternative heating to raise the room temperature to 10°C than
start the air conditioner in heat mode and set it to the desired temperature. Heating by heatpump
will take longer but is cheaper than any other form of heating and ideal for maintaining room
temperature constant.