User manual

Page 7 of 17
CONTROL PANEL AND SETTINGS
This portable air conditioner boasts four functions: cooling, heating, dehumidifying.
The fan has three speeds: high, medium and low
Temperature range settings are: 18--30
0
C
The unit will also display operating function, temperature, fault diagnostic and protective
functions on the LED screen.
Control instruction
：
：：
：
Control panel：
：：
：
When plugged in the unit is automatically in standby status
(1) POWER button
Press this button to turn the unit on and enter cooling mode. Press again and the unit
will switch off.
(2) FUNCTION button
Press this key to choose Cooling, Heating or Dehumidifying Mode
(3),(4) TEMP- and TEMP+ button: sets temperature
In cooling mode, the temperature can range from 17- 30°C
In heating mode, the temperature can range from 15- 25°C
(5) LED display shows the ambient temperature or timer settings while in normal
operation. When the set temperature or the timer is adjusted, the new setting is shown then
the display returns the current set temperature.
By pressing the TEMP+ or TEMP- switch, the required target temperature is briefly
displayed. When pressing the [TIMER] switch, the number of hours to stop / start is briefly
shown until function is achieved or deactivated. In the dehumidification function, „dH“(or
„HP“ upside-down) is shown in the display.
※ The LED display is also used to show error codes should a fault occur, see ERROR
CODES TABLE
ALARM When the internal water tank is full, E4 will be displayed on the LED panel. To