User Manual

Page 10 of 23
(1) STANDBY Button
Press this button to turn the unit on and enter cooling mode. Press again and the unit
will switch off.
(2) TEMP + Button
These are used to increase the desired temperature
In cooling mode, the temperature can be set between 17 – 30°C
In heating mode, the temperature can be set between 15 – 25°C
(3) FUNCTION Button
Press this button to choose between the Cooling, Heating, and Dehumidifying modes.
Please note when changing between heating and cooling modes, the exhaust hose
needs moving onto the appropriate air outlet. In dehumidifying mode, the exhaust
hose should not be connected, but the unit should be set up for continuous drainage.
(4) TIMER Button
The inbuilt timer will allow you to set the unit to turn on or turn off after a set period of time,
Please note only one timer can be used at any time.
ON TIMER
– The timer will turn on the unit automatically after the time set has elapsed.
1. When on standby, press the TIMER button, then set the number of hours time you
desire the unit to start by pressing the TEMP+ and TEMP- buttons.
2. Once the set time has elapsed, the unit will turn on automatically.
3. Press the POWER button before the time has elapsed and the unit will turn on as
normal and the timer will be cancelled
4. The function and fan speed can be set whilst setting the timer.
OFF TIMER
– The timer will turn off the unit automatically after the time set has elapsed.
1. While the unit is operating, press the TIMER button then set the number of hours
time you desire the unit to stop by pressing TEMP+ and TEMP- buttons.
2. Once the set time has elapsed, the unit will turn off automatically.
3. Press the POWER button before the time has elapsed, the timer will be cancelled
and the unit will turn off.
(5) TEMP – Button
This are used to reduce the desired temperature
In cooling mode, the temperature can be set between 17- 30°C
In heating mode, the temperature can be set between 15- 25°C
(6) FAN SPEED Button
Allows the fan speed to be changed between the following options:
HIGH→MEDIUM→LOW and AUTO
• If "AUTO" is selected during cooling function the fan speed will automatically be
adjusted to HIGH, MEDIUM or LOW according to the difference between the
desired temperature and the rooms ambient temperature.
• In Dehumidifying mode, the fan is pre-set to low speed
• In HEATING mode, the fan is pre-set to high speed