USER MANUAL COMPACT 9,000 BTU PORTABLE AIR CONDITIONER Thank you for choosing electriQ Please read this user manual before using this innovative Air Conditioner and keep it safe for future reference. Visit our page www.electriQ.co.
CONTENTS SAFETY INSTRUCTIONS 3 FEATURES 5 PARTS LIST 6 INSTALLATION 7 OPERATION AND SETTINGS 9 REMOTE CONTROL 11 WATER-DRAINAGE 12 MAINTENANCE 13 TROUBLESHOOTING 14 TECHNICAL DATA 15 ELECTRIQ UK SUPPORT 16 Page 2 of 16
SAFETY INSTRUCTIONS Important! • Carefully read the instructions before operating the unit. • This unit must only be connected to a 220-240 V / 50 Hz earthed outlet. • Installation must be in accordance with regulations of the country where the unit is used. • If you are in any doubt about the suitability of your electrical supply have it checked and, if necessary, modified by a qualified electrician. • This air conditioner has been tested and is safe to use.
• • the unit which may have compromised the refrigerant system. Any repairs or maintenance must only be carried out on the unit by a suitably qualified engineer. Before opening and servicing the unit the authorized engineer must be in possession of a copy of the manufacturer’s service manual and must follow the safety information contained within it to ensure all hazards are minimized. The refrigerant system should not be perforated or punctured.
FEATURES ⚫ Self-evaporative system, no external water tank needed. ⚫ Compact design, half the size of a normal unit ⚫ Louvres outlet closes automatically when shutting down the unit, this prevents dust and dirt entering the unit. ⚫ Bright LCD screen, indicates temperature and operation mode. ⚫ Advanced LCD Remote control. ⚫ Compressor protection technology. ⚫ 1-24 hrs start / stop timer. ⚫ 3 speed fan allows user to achieve the best balance between maximum cooling and lowest noise level.
PARTS LIST 1. Castors 2. Handle 3. Control panel 4. Air outlet Louver 5. Air inlet grill 6. Air inlet 7. 8. 9. 10. 11.
INSTALLATION WARNING：Before using this unit, please keep it upright for at least 3-4 hours. This unit can easily be moved from one room to another. While moving the unit please note that it must always be kept upright and then placed on a dry, even surface. 1. Assemble the fishtail connector on to the hose by extending the end of the hose and twisting the fishtail into position (At least 3 full rotations). 2.
4. Make sure the unit is upright and there are no obstructions to the air inlets and outlet grill. The unit should be positioned at least 50cm away from walls or other objects within the room. 5. Fix the other end of the hose to the air-outlet window kit NOTE: The window kit is only designed to be installed with sliding or sash windows or doors. The window kit is not designed or to be used with any other style of windows. However the fish tail adaptor can be used with most windows / doors.
OPERATION AND SETTINGS POWER BUTTON Press to turn the unit “ON” or “OFF” MODE BUTTON Press this button to select between the Cooling, Fan and Dehumidify (Dry) modes COOLING MODE: Cold air will be expelled through the front of the unit and hot air will be expelled through the vent hose. DEHUMIDIFY MODE (DRY): The dehumidify function can only be used when the room temperature is above 17̊C. The unit should be set up without a vent hose, moisture is extracted from the air that passes through the unit.
TIMER BUTTON The in-built timer will allow you to set the unit to turn on or turn off after a set period of time, please note only one timer can be used at any time. ON TIMER – The timer will turn on the unit automatically after the time set has elapsed. 1. With the unit turned off, press the TIMER button, then set the number of hours’ time you desire the unit to start by pressing the UP and DOWN buttons. 2. Once the set time has elapsed, the unit will turn on automatically. 3.
REMOTE CONTROL The majority of functions on the remote are the same as those on the main control panel AUTO-SWING BUTTON After the unit has been turned on and a mode has been selected, press this button and the louver will swing continuously up and down; by pressing this button again the movement will stop and the louver remain fixed in position. CHANGE BETWEEN FARENHEIT AND CELSIUS To change the unit of measurement shown on the display, press the ̊C<->̊F button.
WATER-DRAINAGE MANUAL DRAINAGE: 1. When the internal water tank is full the unit will stop working and display the message “FL” on the display. 2. Shut off the unit and unplug. Try not to move the model abruptly as this may cause water to spill out from internal water tank. 3. Place a tray under the water plug. 4. Unscrew the water plug and unplug the water blocker - water will drain from the internal tank. 5.
MAINTENANCE CLEANING Please shut off the unit and unplug from the mains before cleaning or performing any maintenance CLEAN THE SURFACE Clean the plastic housing with a duster or a soft wet cloth. Do not use chemical solvents (such as benzene, alcohol or gasoline) as they may cause irreversible damage. AIR FILTER CLEANING a) Clean the air filters every 2 weeks. If the air filter is blocked with dust, the unit’s performance will be significantly affected.
TROUBLESHOOTING Do not repair or disassemble the unit by yourself, unauthorized repair attempts will invalidate the warranty and may cause bodily harm. Problem The unit does not work Reason Solution No power supply Power-on and turn on the unit. Water-full indicator illuminated Drain the internal water tank Timer function is active Cancel Timer function Room temperature too low or too Use only in ambient temperatures high between 7-35℃ In direct sunlight Windows or doors open.
TECHNICAL DATA: Capacity Cooling:2.6 kW / 9,000 BTU Rated Power input Running Current Cooling 0.96 kW 4.8 Amps Airflow 360 m3/h Noise 63 db(A) Sound Power 53-57 db(A) Sound Energy Permitted Excessive Operating Pressure Maximum Allowable Pressure 0.8MPa/2.8MPa 1.3MPa/3.8MPa Power Supply 220-240V / 50Hz EER 2.
electriQ UK SUPPORT www.electriQ.co.uk/support Please, for your own convenience, make these simple checks before calling the service line. If the unit still fails to operate call: 0330 390 3061 or complete the online form Has the unit been standing upright for at least 2 hours? Is the unit plugged into the mains? Is the fuse OK? Switch the unit off and wait three minutes to see if the issue is resolved. Restart the unit. 5. Check if the water tank is full. 1. 2. 3. 4.
