User Manual

6
ACCESSORIES
ASSEMBLY INSTRUCTIONS
• Remove the butterfly nuts from each of the U-shaped bolts.
• Place the first U shaped bolt around the base of the radiator and slide the hooked
end of the bolt into one of the inner holes on the mounting plate.
• Fasten the other end of the bolt to the other inner hole using the butterfly nut.
• Repeat with the other mounting plate and U-shaped bolt.
• Remove the nuts from the castors and fit them to the outer holes on the mounting
plate, before securing with the nuts.
Note: The mounting plates should be at opposite ends of the radiator to ensure the
stability of the appliance.
WARNING: Do not operate without the castors. Only operate the heater in an upright
position.
POSITIONING THE HEATER
• Place the unit in an upright position on a flat, stable and heat-resistant surface.
• Ensure that there are no flammable or heat-sensitive materials or substances
within one metre of the front and 50 cm of the rear and sides of the unit.
• Do not cover the heater.
CONNECTING THE HEATER
• Before inserting the plug into a suitable socket, make sure that the unit is intact,
properly assembled and that there are no signs of damage to the appliance or its
power cable.
• To avoid overloading a circuit, connect the unit only to a circuit where no other
equipment is connected.
• When the power switch is in the OFF position, insert the plug into an earthed
socket and turn on the power.
U-Shaped Bolt with Butterfly Nut x 2
Mounting Plate x2
Castor x 4
Remote Control