User Manual

Page 20 of 22
CLEANING AND MAINTENANCE
CLEANING AND STORAGE
ATTENTION: Please shut off the unit and unplug from the mains before cleaning or
performing any maintenance.
Cleaning the surface
Clean the heater with a duster or a soft wet cloth.
Do not use chemical solvents (such as benzene, alcohol or gasoline) as they may cause
irreversible damage. Make sure no water enters the control panel or gaps in the casing.
Do not run the unit until completely dry.
Place the heater in its original box or cover to protect it from dust when not in use.
Store it in a cool dry place.
TROUBLESHOOTING
Do not repair or disassemble the unit by yourself; unauthorized repair attempts will invalidate
the warranty and may cause bodily harm.
Issue
Possible Reason
Solution
No power
1. The power cord is disconnected
2. There is no power from the socket
3. The power switch on the rear of the unit is
turned off.
1. Connect the power cord
2. Check socket is turned on
3. Ensure the power switch on the
rear of the unit is in the On
position
Odour
emission
from the
unit
1. New unit. When the unit is used for the first
time the unit may produce an odour which will
dissipate within a week of use
1. No action required
Strong
vibrations
and noise
1. Unit is not placed on a flat surface
2. The Unit may be damaged
1. Place on a flat surface. May put
an anti-vibration mat underneath
2. If the heater is damaged
discontinue use and contact the
service centre.
If the above solutions do not resolve the problem please contact the service centre.
DECLARATION OF CONFORMITY
Hereby, electriQ declares that this heater is compliant with Directive 2014/53/EU.
The full text of the EU declaration of conformity is available at the following internet
address:
https://www.electriQ.co.uk/content/declaration-of-conformity