User Manual

Page 8 of 22
OPERATION
TURNING ON AND OFF
The Standby button can be pressed to enter and exit standby mode. If the unit
is not to be used for a while, we would advise for it to be turned off using the
switch on the back and unplugged.
CHANGING THE DESIRED ROOM TEMPERATURE
The desired room temperature can be adjusted in both High heat and Low
Heat modes, using the UP and DOWN buttons. After the UP or DOWN button
has been pressed, the temperature display will show the desired temperature.
The desired temperature can be adjusted between 5°C and 50°C.
CHILD LOCK
Press and hold the UP and DOWN buttons for 3 seconds to activate and
deactivate the child lock. When the child lock is activated the Child lock symbol
will be shown on the display and the buttons are disabled on the control panel
until the child lock is deactivated.
CHANGING THE POWER LEVEL
Repeatedly press the PROGRAM button to change between the 3 available
power modes:
High Heat
The heater will operate at High Power(2KW), the desired
temperature can be specified between 5°C and 50°C.
Low Heat
The heater will operate at Low Power (1KW), the desired
temperature can be specified between 5°C and 50°C.
Anti-Frost
The heater will operate to keep the room temperature
between 5°C and 9°C in order to prevent freezing within
the room. The desired temperature cannot be changed.
OPEN WINDOW PROTECTION
If the temperature of the room drops by 5 degrees within a 10 minute period
while the unit is operating, it will assume that a window or door is open and
will enter standby mode to preserve energy. The unit must be turned back on
using the STANDBY button following rectifying the cooling influence.