User Manual
INSTALLING THE HEPA FILTER (OPTIONAL)
The air conditioner can accommodate a HEPA lter which will purify the
air expelled back into the room in any operating mode. These can be
purchased from the stockist using the code:
FIL-ECOSILENTHEPA.
The HEPA lter should be unwrapped and installed in the upper air inlet.
To install, remove the upper lter frame from the air conditioner by
pressing the two clips on the top of the lter frame. Place the HEPA lter
within the lter frame before retting onto the unit.
In order to maintain performance, the lter should be regularly
vacuumed. The lter should be replaced every six months, depending on
usage and air quality.
NOTES:
• The window kit is only designed to be installed with sliding or sash windows or doors. The window
kit is not designed or to be used with any other style of windows.
• The sh tail adaptor can be used without the slide bar with most windows / doors.
• When using the air conditioner ensure that the opening left around the shtail is as small as possible as
the cooling will be less efcient.
• The best form of installation is through a wall duct. By properly venting you expel hot air from your
room while efciently cooling it.
• Your air conditioner should be used without the vent pipe in dry mode. When using dry mode
ensure that an external water tank is used, monitored and regularly emptied before overowing.
Permanent plumbing can be also installed for dry mode or an external uplift water pump can be
set up for unattended use.
IMPORTANT SAFEGUARDS
The length of the soft hose extends from approximately 35 cm to 200 cm. If hose is extended above this
length, the unit may malfunction which can invalidate the warranty. The outlet vent must be well ventilated
and not obstructed as this will cause the unit to overheat. Keep the hose as straight and short as possible
and avoid bending the air hose by more than 30 degrees in order not to reduce the performance of the
unit.
6