USER MANUAL electriQ PORTABLE AIR CONDITIONER ECOSILENT8 ECOSILENT8E ECOSILENT10 ECOSILENT10E 8,000 BTU 10,000 BTU Thank you for choosing electriQ Please read this user manual before using this innovative Air Conditioner and keep it safe for future reference. Visit our page www.electriQ.co.
CONTENTS SAFETY 3 FEATURES AND PARTS LIST 5 INSTALLATION 6 OPERATION 8 REMOTE CONTROL 9 CLEANING AND MAINTENANCE 10 EMPTYING THE INTERNAL WATER TANK 11 TROUBLESHOOTING 12 ERROR CODES 12 SUPPORT 13 TECHNICAL SPECIFICATION 14 2
SAFETY INSTRUCTIONS Important! • Carefully read the instructions before operating the unit • This appliance is for indoor use only. • Rating: This unit must be only connected to a 220-240 V / 50 Hz earthed outlet. • Installation must be in accordance with regulations of the country where the unit is used. • If you are in any doubt about the suitability of your electrical supply have it checked and, if necessary, modified by a qualified electrician. • This air conditioner has been tested and is safe to use.
• The appliance must be placed in a room without sources of ignition (for example: open flames, an operating gas appliance or an operating electric heater). • R290 refrigerant gas complies with European environmental directives. • R290 has a low GWP (Global Warming Potential) of 3. • The ECOSILENT8 / 8E contains about 220 g of R290 refrigerant gas. • The ECOSILENT10 / 10E contains about 280 g of R290 refrigerant gas. • Do not use or store in an unventilated space with an area smaller than 10.
FEATURES AND PARTS LIST FEATURES • 3 in 1 Cooling, Fan, Dehumidifier great for Rooms up to 20 sqm. • 5 speed DC fan: balancing quiet operation with performance. • SmartCool Logic for Improved Energy Efficiency. • 24 Hours Start / Stop Timer • Digital Thermostat. • Remote Control. • Castors and Handles for Enhanced Portability. • Auto-Restart to retain the settings in the event of power failure.
INSTALLATION WARNING: Before using this unit, please keep it upright for at least 3-4 hours. This unit can easily be moved from one room to another. While moving the unit please note that it must always be kept upright and then placed on an even surface. 1. Attach the fishtail connector to the end of the hose, by extending the end and twisting until firmly attached (At least 3 full rotations). 2.
NOTES: • The window kit is only designed to be installed with sliding or sash windows or doors. The window kit is not designed to be used with any other style of windows. • The fish tail adaptor can be used without the slide bar with most windows / doors. • When using the air conditioner ensure that the opening around the fishtail adaptor is as small as possible to ensure the efficiency of the unit is not reduced. • The best form of installation is through a wall duct.
OPERATION Press the POWER button to turn the unit ON or OFF. Press the MODE button to cycle between the 4 modes, the indicator for the selected mode will be illuminated. COOL: The room is cooled with the cold air expelled through the front air outlet while hot air is expelled through the vent pipe. The desired room temperature can be set between 17 and 30 degrees using the + and – buttons, and the fan speed can be changed using the SPEED button. FAN: The fan speed can be changed pressing the SPEED button.
REMOTE CONTROL POWER TIMER DOWN UP SLEEP FAN COOL DRY HIGH LOW Press to turn the unit on or off. Press to set the timer. Press to decrease the desired temperature or timer duration. Press to increase the desired temperature or timer duration. Press the sleep button to enter sleep mode. Press to enter fan / air purify mode. Press to enter cool mode. Press to enter dry (dehumidify) mode. Press to enter high (F5) speed fan. Press to enter low (F1) speed fan.
MAINTENANCE AND CLEANING PLEASE SHUT OFF THE UNIT AND UNPLUG FROM THE MAINS BEFORE CLEANING OR PERFORMING ANY MAINTENANCE CLEAN THE SURFACE Clean the surface of the machine with a wet soft cloth. Do not use chemicals, such as benzene, alcohol, gasoline, etc; otherwise, as this may cause damage to the surface and or the internal workings of the machine AIR FILTER CLEANING If the filter screen is clogged with dust, the effectiveness of the air conditioner is reduced.
EMPTYING THE INTERNAL WATER TANK MANUAL DRAINAGE: When the internal water tank is full the unit will stop working, and the unit will display E7. Turn off the unit and unplug. Try not to move the model abruptly as this may cause the water in the internal tank to spill out. Place a tray under the lower water plug or place the unit in a drainage area. Unscrew the drain plug cap and remove the rubber stopper - water will drain from the internal tank.
TROUBLESHOOTING Do not repair or disassemble the air conditioning. Unqualified repair will invalidate the warranty and may lead to failure, causing injuries and property damage. Only use it as directed in this user manual and only perform operations advised here. Problems The air conditioner does not work. Reasons Solutions There is no electricity. Turn it on after connecting it to a socket with electricity. The display shows "E7".
APPENDIX Disposal: Do not dispose this product as unsorted municipal waste. Collection of such waste must be handled separately as special treatment is necessary. Recycling facilities are now available for all customers at which you can deposit your old electrical products. Customers will be able to take any old electrical equipment to participating civic amenity sites run by their local councils.
TECHNICAL DATA Model Capacity Cooling Rated Input Running Current EcoSilent10 EcoSilent10E 2930 W 870W 5.0 A 4.0 A DC motor with 5 fan speeds. 350m3/h Airflow EER rate A R290/280g R290/220g Sound power level 61dB(A) Thermostat 17-30oC Maximum working pressure of suction/exhaust side 1.0/3.5MPa Maximum Allowable Pressure 3.
