USER MANUAL BLADELESS HEATER WITH AMBIENT LIGHT eiQ-AM09 eiQ-AM09B White Black Thank you for choosing electriQ Please read this user manual before using this heater and keep it safe for future reference. Visit our page www.electriQ.co.
CONTENTS SAFETY INSTRUCTIONS 3 FEATURES 5 DIAGRAM 5 OPERATION 6 CONTROL PANEL AND SETTINGS 6 REMOTE CONTROL 7 MAINTENANCE 8 TROUBLE SHOOTING 8 TECHNICAL DATA 9 SUPPORT 9 PRODUCT FICHE 10 Page 2 of 10
SAFETY INSTRUCTIONS Important! Carefully read the instructions before operating the unit This appliance is for indoor use only. Rating: This unit must be only connected to a 220-240 V / 50 Hz earthed outlet. Installation must be in accordance with regulations of the country where the unit is used. If you are in any doubt about the suitability of your electrical supply have it checked and, if necessary, modified by a qualified electrician. This heater has been tested and is safe to use.
The heater is designed to be used at temperatures above -20°C. If it is exposed to temperatures below this, it must be allowed to warm above this level before operation. Do not attempt to repair, disassemble or modify the appliance. This unit contains no user-serviceable parts. Always unplug or disconnect the appliance from the mains power supply when not in use, or when moving or cleaning it. Do not pull the cord to unplug the heater. Keep the heater clean.
eiQ-AM09 BLADELESS HEATER FEATURES Slim design takes minimal space High Speed Motor with Fan mode and 2 Heat settings Swing Function 12 hour standby timer. Remote Control allowing all functions to be changed. Built in ambient light.
OPERATION Your heater may be operated by using either the manual controls located on the front of the fan or by your remote control. POWER SWITCH ON THE BACK OF THE UNIT Used to turn the bladeless heater ON and OFF. This should be used to turn off the appliance before leaving unattended. CONTROL PANEL AND SETTINGS ON/OFF BUTTON Used to turn the bladeless heater ON and OFF. SWING BUTTON Press to turn the Swing function on and off.
REMOTE CONTROL Your bladeless heater is supplied with a remote, which allows full control of all the unit’s functions. ON/OFF: Turns the fan On and Off MODE: Cycles between Fan, Low Heat and High Heat. TIMER: Press repeatedly to set the Off timer in 1 hour intervals. The time set will be displayed on the unit. SWING: Press to turn the Swing Function On and Off. LIGHT: Press to change the ambient light between Off, Green, Purple and Blue. TEM+: Press to increase the desired room temperature.
MAINTENANCE CLEANING AND STORAGE ATTENTION: Please shut off the unit and unplug from the mains before cleaning or performing any maintenance. Cleaning the surface Clean the heater with a duster or a soft wet cloth. Do not use chemical solvents (such as benzene, alcohol or gasoline) as they may cause irreversible damage. Make sure no water enters the control panel or gaps in the casing. Do not run the unit until completely dry.
TECHNICAL DATA Model Cable length Rated Input Power Supply Net Weight Dimensions eiQ-AM09 / eiQ-AM09B 1.5 meters 2 KW 220-240V/50Hz 3.0Kg 570mm x 290mm x 170mm electriQ UK SUPPORT www.electriQ.co.uk/support Please, for your own convenience, make these simple checks before calling the service line. If the unit still fails to operate call: 0871 620 1057 or complete the online form 1. Is the unit plugged into the mains? 2. Is the fuse OK? 3.
PRODUCT FICHE Model Identifier: eiQ-AM09 Item Symbol / eiQAM09B Value Unit Heat Output Item Unit Type of heat input, for electric storage local space heaters only (select one) Nominal heat output Pnom 2.0 kW manual heat charge control, with integrated thermostat No Minimal heat output Pmin 1.0 kW manual heat charge control with room and/or outdoor temperature feedback No Maximum continuous heat output Pmax 2.
