USER MANUAL CANOPY COOKER HOOD KITCHEN EXTRACTOR FAN IN SILVER eiQCH110CEILING Thank you for choosing your electriQ cooker hood. This instruction manual is designed to provide you with all required instructions related to the installation, use and maintenance of the appliance. In order to operate the unit correctly and safely, please read this instruction manual carefully before installation and usage.
CONTENTS SAFETY 3 PARTS LIST 5 VENTING INFORMATION 6 INSTALLATION 7 OPERATION 10 REMOTE CONTROL 11 CLEANING AND MAINTENANCE 12 FILTER INFORMATION 12 BULB REPLACEMENT 14 TROUBLESHOOTING 14 PRODUCT FICHE 15 SUPPORT 16 2
SAFETY PRECAUTIONS Whilst this product is compliant with all safety requirements, incorrect or inappropriate use can lead to both personal injury and potential damage to property. Please read the contents of this instruction booklet thoroughly before fitting or using this appliance. • The cooker hood must be installed in accordance with the installation instructions and all measurements followed. • All installation work must be carried out by a competent person or qualified electrician.
• • • • • • • • • • and 75cm gives peak efficiency. The air must not be discharged into a flue that is used for exhausting fumes from appliances burning gas or other fuels. When the hood is vented externally and used with appliances which burn fuel (e.g. gas, oil, wood) the area must be sufficiently ventilated to ensure safe operation. Fresh air must be allowed to freely enter the room to prevent a partial vacuum. A partial vacuum can starve the heating appliance of oxygen, impairing combustion.
PARTS LIST 138B 110cm No.
V-FLAP INSTALLATION OPTIONS FOR VENTILATION This hood can be set up for either external venting or recirculation of the air. The type of setup should be decided before commencing installation. EXTERNAL VENTING A flexible pipe is provided which allows the cooking odours to be extracted outside. If this is the chosen installation method consideration to the route of the vent pipe should be made. The unit is also provided with an adaptor allowing pre-existing 120mm ducting to be used to vent the unit.
INSTALLATION 1. The cooker hood should not be placed at a distance of no more than 1500mm from the cooking surface for the best performance. Refer to Pic 1. 2. The ceiling must can bear at least 120KGs weight, and the thickness of the ceiling must be greater than 30MM. 3. Drill 14pcs φ 8mm holes on the ceiling once the installation height has been determined. 4.
5. Decide on the direction of the air outlet. ①/②/③/④ 6. open the decorative plate in order, and take out the filter. 7. Refer to Pic 7, unscrew and take away the 4 pcs ST4*8mm screws that on the panel decorative strip. 8. Unscrew the 8pcs machine silk from the bottom of the cabinet housing and rotate it by 90°/180°/270° to choose the direction of the outlet, then screw the 8 pcs machine silk to fix the housing well. 9. Install the panel decorative strip and filter.
10. Connect the 4 adjustable angle iron brackets with the housing using M4*12mm machine silk screws. Lift up the housing and use M4*12mm machine silk screws and M4 nut with gasket to fix the housing onto the 2 hanging board and pull the expansion pipe outside. (Note: The expansion pipe must be fixed on the housing firmly.) 11. After installing the housing to the hanging board, use a screwdriver or straight to adjust the angle iron bracket, direct the housing level position and height till it is suitable.
OPERATION OPERATION POWER TIMER DESCRIPTION Press the power button to turn the unit on and off. When the unit is turned on the hood will start automatically at low fan speed. When the hood is turned off, the hood will remember the last speed used and start at the speed when next turned on. The timer button is used to set the timer. Press the button once to enter the function, and press again to cancel the timer. The timer is only available when the unit is powered on.
REMOTE CONTROL 15 seconds after the cooker hood is connected to the power supply, press and hold for 5 seconds, the indicator lights will begin flashing. The cooker hood is in connection mode. Press any button on remote control to confirm the connection. The connection process finished and the remote control can be used for speed selection, lighting and timer setting.
CLEANING AND MAINTENANCE Disconnect range hood from power supply before cleaning or servicing. 1. Clean the hood surface frequently using mild detergent and a warm damp sponge or cloth. 2. Do not use harsh alkalis or abrasives. 3. Avoid the use of scouring powers or dishwasher compounds. 4. If the optional carbon filter is being used, these cannot be cleaned and require replacing every 2-3 months depending on frequency of use. They are available from the retailer who supplied your hood.
CARBON FILTER-not supplied Activated carbon filter can be used to trap odors. Normally the activated carbon filter should be changed at three or six months according to your cooking habit. The installation procedure of activated carbon filter is as below. Attention for outdoor ventilation of cooker hood: If you choose②or④ air direction, you need to remove the filter and panel decorative strip according to steps “6” and “7” of INSTALLATION to install and remove carbon filters. 1.
TROUBLESHOOTING Fault Cause Solution The fan blade is jammed. Light on, but fan does not work Both light and fan do not work Excessive Vibration Suction performance not good The motor is damaged. Switch off the unit. Repair to be carried out by qualified service personnel only. Power cord loose Plug in to the power supply again. The fan blade is damaged. Switch off the unit. Repair to be carried out by qualified service personnel only. Switch off the unit.
PRODUCT FICHE Symbol Model identification Annual Energy Consumption Time increase factor Fluid Dynamic Efficiency Fluid Dynamic Efficiency class Energy Efficiency Index Energy Efficiency class Maximum air flow - boost setting Maximum airflow -highest setting Measured airflow rate at the best efficiency Measured air pressure at best efficiency point Measured electric power input at best efficiency point Nominal power of the lighting system Average illumination of the lighting system on the cooking surface Me
electriQ UK SUPPORT www.electriQ.co.uk/support Call: 0330 390 3061 Office hours: 9AM - 5PM Monday to Friday www.electriQ.co.uk Unit J6, Lowfields Business Park Lowfields Way, Elland West Yorkshire, HX5 9DA Recycling facilities are now available for all customers at which you can deposit your old electrical products. Customers will be able to take any old electrical equipment to participating sites run by their local councils.
