User Manual

Remove the filter as shown in the Installation section. Clean it with a soft

nylon brush in a mild solution of warm water and a small amount of washing

up liquid. Washing up liquid alone should not be used. After cleaning, allow

the filter to drain and then dry thoroughly.

The grease filter may also be dishwasher cleaned; using a 60°C programme,

with the filter upright (short sides upright) in the lower basket. Please be

aware some dishwasher cleaning agents can permanently discolour the filter,

though this will not affect its performance.

Replacement grease filters are available from the same stockist from which

you purchased the hood:

60cm models: eiQAL03E860 x 1

III. Replacement for Activated Carbon Filter

These are only required in units that have been installed in recirculation mode

(not vented to the outside). This filter traps odours and must be replaced

ideally every 3-6 months depending on how frequently the cooker hood has

been used. They are not washable or reusable.

eiQCF110 Carbon Filter Pack– fits model eiQCHC60W

IV. Light Replacement

Press the lamp surface and anticlockwise take out the lamp.

Change a new lamp and clockwise fix the lamp back.

Important: The light fitting must be replaced by the manufacturer,

its service agent or similarly qualified persons.

Before changing the bulb, ensure the hood is turned off and the

power is disconnected before attempting to change the bulb.

Wait until the flitting has cooled down before commencing

replacement.