User Manual

8
5. The 2 x airflaps should be installed at this stage, as access is easier before
the unit is wall mounted. On the top of the Hood Unit itself, where the air outlet
vent is located, the 2 x flaps should be carefully installed, bending very slightly
so the lugs at each end locate into the holes, enabling flaps to pivot upwards
when the unit is in operation, opening up the outlet fully for the air to pass
through. Please note: the small spindles/lugs at each end of each flap locate
into the holes on the housing, not the grooves above them.
6. Hang on the cooker hood on wall.
7. Attach the exhaust pipe onto the one-way-valve as shown below, and fix
the pipe on the valve by cable tie. The adaptor can be used at this stage, if
you already have existing smaller diameter venting in place to connect.