User Manual

MAINTENANCE

Before cleaning, switch the unit off and pull out the plug, or switch off at the relevant mains

switch if the unit has been hard-wired in. Make sure the unit has no power being fed to it.

I. REGULAR CLEANING

Use a soft cloth moistened with hand-warm mildly soapy water or household cleaning

detergent. Never use metal pads, chemicals, abrasive material or a stiff brush to clean the unit.

Note! Do not use a steam-cleaner to clean the hood; electrical components could be damaged

or short-circuit as a result.

II. MONTHLY CLEANING FOR METALLIC ANTI-GREASE FILTER

ESSENTIAL NOTE: Clean the filter every month; an excessive build-up of grease can become

a fire hazard. The filter collects grease, smoke and dust, so the filter directly affects the

efficiency of the cooker hood. If it’s not cleaned, the grease residue (potentially flammable) will

saturate on the filter.

Remove the filter as shown in the Installation section. Clean it with a soft nylon brush in a mild

solution of warm water and a small amount of washing up liquid. Washing up liquid alone

should not be used. After cleaning, allow the filter to drain and then dry thoroughly.

The grease filter may also be dishwasher cleaned; using a 60°C program, with the filter upright

(short sides upright) in the lower basket. Please be aware some dishwasher cleaning agents

can permanently discolour the filter, though this will not affects its performance.

Replacement grease filters are available from the same stockist from which you purchased the

hood:

60cm models: eiQTMGREASE1 x 2

90cm models: eIQTMGREASE2 x 3

III. REPLACEMENT FOR ACTIVATED CARBON FILTER

These are only required in units that have been installed in recirculation mode (not vented to

the outside). This filter traps odours and must be replaced ideally every 3-6 months depending

on how frequently the cooker hood has been used.

eIQTMCARBONCHIM (Carbon Filter Pack of 2 – fits both 60cm and 90cm models)