User Manual

IV. LIGHT BULB REPLACEMENT

This hood is fitted with an LED light unit, which under normal operation can last the lifetime of

the hood. In the event that it does fail, replacement light units are available from the same

retailer the hood was purchased from.

Before changing the fitting, ensure the hood is turned off and the power is removed by either

unplugging the unit or switching off at the pole switch (if installed) before attempting to

change the bulb. Wait until the filling has cooled down before commencing replacement.

1. Remove the aluminum grease filter from the hood.

2. Locate the top of the light fitting and squeeze the spring

clips, while pushing the fitting out of the base of the

hood.

3. Follow the wire from the light unit and find the power

connector on the lead.

4. Disconnect the power connector from it, ensuring the light

fitting is not allowed to fall from the unit

5. Replace with a new light unit, which after connecting the electrical connection, should be

pushed into position on the base of the hood.

6. Refit the aluminum grease filters.

Important

• If a bulb is found to be defective, it should be replaced immediately.

• Always switch off the electricity supply before carrying out any operations on the

appliance. When handling the bulb, make sure it has completely cooled down before any

direct contact to hands.